The Dependence of ECR-CVD Processing Parameters on Deposition Uniformity of Hydrogenated Amorphous Silicon (a-Si:H) Films

Abstract:

The uniformity improvement of high deposition rate in hydrogenated amorphous silicon (a-Si:H) film deposited by electron cyclotron resonance chemical vapor deposition (ECR-CVD) is very essential for a large substrate in PV solar industry. In order to improve the uniformity in depositing thin film in large area, the auxiliary magnetic coils were designed and installed in ECR-CVD to modify the distribution of magnetic field. In addition, the dependence of the other ECR-CVD processing parameters such as resonance position, microwave power, working pressure, and substrate temperature were investigated. The results indicated that more uniform a-Si:H film could be obtained when working pressure was decreased. By using finite element analysis, it was found that location of turbo pump would impact gas flow field and this effect would become more significant at high pressure. Increasing microwave power, increasing horizontal gradient of the magnetic field to the substrate, and forming Cusp magnetic field could enhance ECR-CVD deposition uniformity greatly. However, the plasma location and substrate temperature were not major factors affecting a-Si:H film uniformity in ECR-CVD process. Finally, the optimal and the best 3.8% in uniformity could be achieved in 150mm diameter when the ratio of magnetic field strength at wafer edge to wafer center is 215%, working pressure is 1.5 mtorr, microwave power density is 4W/cm², and substrate temperature is 180°C.

• Periodical: Key Engineering Materials (Volumes 656-657)
• Pages: 92-100
• DOI: https://doi.org/10.4028/www.scientific.net/KEM.656-657.92
• Online since: July 2015
• Authors: Li Cheng Hu, Yong Shiang Li, Chien Chieh Lee, Jeng Yang Cheng, I Chen Chen, Tomi T. Li*
• Keywords: ECR-CVD, Film Thickness Uniformity, Hydrogenated Amorphous Silicon

References

[1] T. Ono, M. Oda, C. Takahashi, and S. Matsuo, Reactive ion stream etching utilizing electron cyclotron resonance plasma, J. Vac. Sci. Technol. B, 4 (1986) 696-700.

DOI: 10.1116/1.583599

[2] S. Matsuo and M. Kiuchi, Low Temperature Chemical Vapor Deposition Method Utilizing an Electron Cyclotron Resonance Plasma, Jpn. J. Appl. Phys. 22 (1983) L210-L212.

DOI: 10.1143/jjap.22.l210

[3] Y. Ueda, Y. Inoue, S. Shinohara, and Y. Kawai, Deposition of large area amorphous silicon films by ECR plasma CVD, Vacuum, 48 (1997) 119-122.

DOI: 10.1016/s0042-207x(96)00244-8

[4] M. Zhang, Y. Nakayama, S. Nonoyama, and K. Wakita, Relationship between film quality and deposition rate for a-Si: H by ECR plasma CVD, J. Non-Cryst. Solids 164-166 (1993) 63-66.

DOI: 10.1016/0022-3093(93)90492-g

[5] R. Kar, S.A. Barve, S.B. Singh, D.N. Barve, N. Chand, and D.S. Patil, Diagnostics of microwave ECR generated plasma: Effect of contaminated reference electrode, J. Vacuum. 85 (2010) 151-155.

DOI: 10.1016/j.vacuum.2010.05.003

[6] A. Murai, I. Ohya, T. Yasui, H. Tahara, and T. Yoshikawa, Generation of large-area disk-shaped ECR plasma for diamond deposition, Thin Solid Films. 281 (1996) 146-148.

DOI: 10.1016/0040-6090(96)08731-7

[7] K. Nakase, T. Shibata, T. Yasui, H. Tahara, T. Yoshikawa, Sheet-shaped ECR plasma generation using permanent magnets for material processing, Thin Solid Films. 281 (1996) 152-154.

DOI: 10.1016/0040-6090(96)08598-7

[8] C.S. Ren, D.Z. Wang, J. Zhang, X.L. Qi, Y.N. Wang, The effect of external cusp magnetic field on Ar ICP characteristics, Vacuum 83 (2009) 423–426.

DOI: 10.1016/j.vacuum.2008.04.074

[9] H. Nishimura, M. Kiuchi and S. Matsuo, Processing Uniformity Improvement by Magnetic Field Distribution Control in Electron Cyclotron Resonance Plasma Chamber, Jpn. J. Appl. Phys. 32 (1993) 3229326.

DOI: 10.1143/jjap.32.322

[10] Y. Kawai, K. Uchino, H. Muta, S. Kawai, and T. Rowf, Development of large diameter ECR plasma source, J. Vacuum. 84 (2010) 1381-1384.

DOI: 10.1016/j.vacuum.2009.12.023

[11] L. C. Hu, Y. P. Chen, J.Y. Chang, J. J. Lee, I.C. Chen and Tomi T. Li, Improvements on the Uniformity of a-Si Solar Thin Films by Using Auxiliary Magnetic Field, ECS Trans. 34. 1(2011) 1097-1101.

DOI: 10.1149/1.3567720

[12] H. Xiao, Introduction to semiconductor manufacturing technology , 2nd ed., Princeton-Hall Inc., New Jersey, (2001).

[13] S. E. Lassig and J. D. Tucker, Intermetal dielectric deposition by electron cyclotron resonance chemical vapor deposition (ECR CVD), Microelectronics J. 26 (1995) 11-23.

DOI: 10.1016/0026-2692(96)81856-8