Preface
Determining the Optimal Mode of the Inconel 718 Alloy Deposition at a Direct Laser Deposition Plant
p.3
p.3
Modeling and Optimization of Additive Systems Based on Intelligent Technologies
p.13
p.13
Influence of Surfacing Modes on the Formation of Pores in the Deposited Metal Produced by Wire Arc Additive Method (WAAM) Using Al-Mg Alloy
p.20
p.20
Mortar for 3D Printing Based on Gypsum Binders
p.26
p.26
Measurement Assurance of Additive Manufacturing on the Example of Laser Surface Polishing Products by Remelting
p.32
p.32
Optimization of Temperature Regimes of the Hotend for Devices of Additive Manufacturing
p.41
p.41
Stress Simulation of the Structure of a Stretch Die Made by Fused Deposition Modeling
p.47
p.47
Experimental Investigation of Nozzle Clogging Using Vibration Signal-Based Condition Monitoring for Fused Deposition Modeling
p.55
p.55
Preface
Abstract:
You might also be interested in these eBooks
Info:
Periodical:
Materials Science Forum (Volume 1037)
Online since:
July 2021
Сopyright:
© 2021 Trans Tech Publications Ltd. All Rights Reserved
Share: