For Libraries For Publication Open Access Downloads About Us Contact Us
Paper Titles
On the Development of Grain-Orientation-Dependent and Inter-Phase Stresses in a Super Duplex Stainless Steel under Uniaxial Loading
p.917
Evolution of Microstrains at Cyclic Incremental Deformation of Steel 42CrMo4
p.925
In Situ X-Ray Stress Analysis for the Highly Textured Mg-Base Wrought Alloy AZ31
p.931
Formation and Interpretation of Micro Residual Stresses in Cold Deformed Brass Alloys
p.937
X-Ray Stress Estimation of Carbide in Spheroidized JIS SK5 Steel
p.943
Mechanical Properties of Hydroxyapatite in Bone at the Interface with Implants
p.951
The Measurement of Stresses within Oxides Produced on Austenitic and Ferritic Steels Using Raman Spectroscopy
p.957
Dependence of Oxidation Behavior and Residual Stresses in Oxide Layers on Armco Iron Substrate Surface Condition
p.963
Residual Stress Analysis in Reed Pipe Brass Tongues of Historic Organs
p.969

X-Ray Stress Estimation of Carbide in Spheroidized JIS SK5 Steel

Article Preview

Abstract:

The low volume fraction of carbide phase in carbon steel determines that it is difficult to estimate the stress state in it by diffraction method. In the present study, different from the studies before, we improve the technique of surface treatment on specimen and have successfully finished the stress estimations of carbide phase in carbon steels by X-ray diffraction method under normal conditions. Moreover, we investigate the affection of spherical cementite particle size on the residual stress distribution in both phases during the plastic deformed steels. We observed that the steels with small-sized cementite particles showed higher stress states than the steels with relatively large-sized cementite particles.

You might also be interested in these eBooks
Residual Stresses VII, ECRS7 View Preview

Info:

Periodical:

Materials Science Forum (Volumes 524-525)

Pages:

943-948

DOI:

https://doi.org/10.4028/www.scientific.net/MSF.524-525.943

Citation:

Cite this paper

Online since:

September 2006

Authors:

Lei Che, Masahide Gotoh, Yoshiaki Horimoto, Yukio Hirose

Keywords:

Cementite, Four-Point Bending, Residual Stress, Steel, Surface Treatment, Tensile, X-Ray

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

© 2006 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

References

[1] D.V. Wilson and Y.A. Konnan: Acta Metall., Vol. 12 (1964), p.617.

Google Scholar

[2] D.V. Wilson and P.S. Bate: Acta Metall., Vol. 34, No. 6 (1986), p.1107.

Google Scholar

[3] T. Hanabusa, J. Fukura and H. Fujiwara: Jpn. Soc. Mech. Eng., Vol. 35 (1969), p.237.

Google Scholar

[4] T. Hanabusa, H. Fujiwara and M. Nishida: Inter. Conf. on Residual Stresses 2, (1989), p.555.

Google Scholar

[5] R.A. Winholtz, J.B. Cohen: Adv. X-ray Anal., Vol. 32 (1989), p.341.

Google Scholar

[6] R.A. Winholtz and J.B. Cohen: Metall. Trans. A, Vol. 23 (1992), p.341.

Google Scholar

[7] R.A. Winholtz and J.B. Cohen: Mater. Sci. and Eng., A154 (1992), p.155.

Google Scholar

[8] K. Inal, J.L. Lebrun and M. Belassel: Metall. and Mater. Trans. A, Vol. 35 (2004), p.2361.

Google Scholar

[9] M. Belassel, V. Ji, and J.L. Lebrun et al.: Journal De Physique, Vol. 4 (1994), p.261.

Google Scholar

[10] M. Belassel, J.L. Lebrun, and S. Denis et al.: Inter. Conf. on Residual Stresses 4, (1994), p.392.

Google Scholar

[11] P.B. Prangnell, T. Downes and P.J. Withers et al.: Mater. Sci. and Eng., A197 (1995), p.215.

Google Scholar

[12] T. Sasaki, Z. Lin and Y. Hirose: Jpn. Soc. Mech. Eng., Vol. 63A (1997).

Google Scholar

© 2025 Trans Tech Publications Ltd. All rights are reserved, including those for text and data mining, AI training, and similar technologies. For open access content, terms of the Creative Commons licensing CC-BY are applied.
Scientific.Net is a registered trademark of Trans Tech Publications Ltd.