Microstructure Characterization of the Cu-Ti-C Composites Prepared by Mechanical Alloying and Spark Plasma Sintering

Jian Zhuang; Yong Bing Liu; Zhan Yi Cao; Yue Ying Li; X.R. Liu

doi:10.4028/www.scientific.net/MSF.610-613.629

Paper Titles

Fabrication and Properties of Large-Area Silicon Nanowire Arrays
p.604

A Novel Inorganic Ion Conductor Electrochromic Device: MoO₃/LiAlO₂/NiO_x
p.610

Photoluminescence Properties Influenced by Calcining Condition and Doping Concentration of Nano-Sized ZnGa₂O₄: Cr³⁺
p.616

Study of a New Chromium Carbide Reinforced Ni₃Al Matrix Composite Hardfacing Material on IC6SX
p.623

Microstructure Characterization of the Cu-Ti-C Composites Prepared by Mechanical Alloying and Spark Plasma Sintering
p.629

Finite Element Simulation of Effects of Process Parameters on Deposition Rate of SiC by Chemical Vapor Deposition
p.635

Study on the Tribological Properties of Low-Power Plasma-Sprayed Al-Cu-Cr Quasicrystalline Coating
p.641

Porosity Ratio and Anti-Corrosion Properties of Cr/CrN Films Synthesized by Unbalanced Magnetron Sputtering
p.647

The Lubrication Properties of Diamond-Like Carbon Coatings in Engine Oil
p.652

HomeMaterials Science ForumMaterials Science Forum Vols. 610-613Microstructure Characterization of the Cu-Ti-C...

Microstructure Characterization of the Cu-Ti-C Composites Prepared by Mechanical Alloying and Spark Plasma Sintering

Abstract:

The evenly dispersed Cu-Ti-C composites have been synthesized successfully from the element powders by mechanical alloying (MA) and spark plasma sintering（SPS）techniques. The evolution of microstructure with different processing parameters has been investigated by XRD and SEM. The Cu-TiC and the Cu-Ti2Cu3-C composites with different hardness and density were obtained from different content of Cu, milling time and sintering temperature. The effect of Cu content in the compound powders, milling times and sintering temperatures on the solid solution and reaction process of Cu-Ti-C system was also discussed and analyzed.