Drawing and Property of 316L Extra Fine Stainless Steel Wires

Shi Feng Liu; Ping Xu; Bo Jian Wang

doi:10.4028/www.scientific.net/MSF.724.331

Paper Titles

Synthesis of Layered-Ternary Ti₂AlC/Al₂O₃ Composites by an In Situ Reaction and Hot Pressing Sintering
p.315

Microstructure Evolution during Combustion Synthesis of Ni/Ni-Aluminide Laminated Composites
p.319

Effect of Sintering Temperature on the Microstructure and Electrical Properties of SnO₂-Based Varistors
p.323

Effect of Calcination of the Raw Materials on the Microstructure and Electrical Properties of ZnO-Based Linear Resistance Ceramics
p.327

Drawing and Property of 316L Extra Fine Stainless Steel Wires
p.331

Effect of Ti, Al and Cu Addition on Structural Evolution and Phase Constitution of FeCoNi System Equimolar Alloys
p.335

Effect of Impact Angle on Erosion Wear Behaviours of SiC_p/Cast Iron Surface Composite
p.339

A Study on Reaction Bonded Ceramics Fabricated by Silicon Infiltration to B₄C Preforms
p.343

Fabrication of Porous SiC/SiAlON Composites Using Semi Coke and Fly Ash as Raw Material
p.347

HomeMaterials Science ForumMaterials Science Forum Vol. 724Drawing and Property of 316L Extra Fine Stainless...

Drawing and Property of 316L Extra Fine Stainless Steel Wires

Abstract:

The purpose of this paper is to study the compression ratio per pass, drawing rules of three differential commercial 316L stainless steel wires during drawing extra fine stainless steel processing. In addition, the influence of chemical composite on the mechanical property has been discussed as well. The results indicate that the tensile strength of austenite stainless steel wires was increased obviously by multi-passes drawing. The strength-enhancing effect of wire drawing can be substantial.