Paper Titles

An Advanced Dynamic Repair of Edge Crack Aluminum Plate with a Composite Patch
p.716

Modelling the Combined Effect of Room Temperature Storage and Cold Deformation on the Age-Hardening Behaviour of Al-Mg-Si Alloys-Part 2
p.722

Modeling of Static and Geometric Dynamic Recrystallization during Hot Extrusion of Al-Mg-Si Alloy
p.728

Analysis of the Rate of Recovery and Recrystallization in Pure Aluminum by a New Rate Equation
p.734

Phase Field Modeling of Solute Trapping in a Al-Sn Alloy during Rapid Solidification
p.740

Grain Refinement Mechanism of Al-5Ti-1B Master Alloy by Ab Initio Calculations
p.746

Effect of Reloading on Dynamic Recrystallization in Shock Deformed Aluminum Alloy
p.755

Mechanical Milling of Quasicrystalline Al-Cu-Fe Alloys
p.761

Aging and Precipitation Behavior in Supersaturated Al-2%Fe Alloy Produced by High-Pressure Torsion
p.766

HomeMaterials Science ForumMaterials Science Forum Vols. 794-796Phase Field Modeling of Solute Trapping in a Al-Sn...

Phase Field Modeling of Solute Trapping in a Al-Sn Alloy during Rapid Solidification

Article Preview

Abstract:

During rapid solidification, interfaces are often driven far from equilibrium and the "solute trapping" phenomenon is usually observed. Very recently, a phase field model with finite interface dissipation, in which separate kinetic equations are assigned to each phase concentration instead of an equilibrium partitioning condition, has been newly developed. By introducing the so-called interface permeability, the phase field model with finite interface dissipation can nicely describe solute trapping during solidification in the length scale of micrometer. This model was then applied to perform a phase field simulation in a Al-Sn alloy (Al-0.2 at.% Sn) during rapid solidification. A simplified linear phase diagram was constructed for providing the reliable driving force and potential information. The other thermophysical parameters, such as interface energy and diffusivities, were directly taken from the literature. As for the interface mobility, it was estimated via a kinetic relationship in the present work. According to the present phase field simulation, the interface velocity increases as temperature decreases, resulting in the enhancement of solute trapping. Moreover, the simulated solute segregation coefficients in Al-0.2 at.% Sn can nicely reproduce the experimental data.

You might also be interested in these eBooks

Aluminium Alloys 2014 - ICAA14

Info:

Periodical:

Materials Science Forum (Volumes 794-796)

Pages:

740-745

DOI:

https://doi.org/10.4028/www.scientific.net/MSF.794-796.740

Citation:

Cite this paper

Online since:

June 2014

Authors:

Xiong Yang, Li Jun Zhang*, Yong Du

Keywords:

Al-Sn Alloy, Phase Field Modeling, Rapid Solidification, Solute Trapping

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

© 2014 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

* - Corresponding Author

[1] W. Kurz, D.J. Fisher, Fundamental of Solidification, Fourth ed., Switzerland, (1998).

[2] R. Kobayashi, Modeling and numerical simulations of dendritic crystal growth, Physica D 63 (1993) 410-423.

DOI: 10.1016/0167-2789(93)90120-p

[3] A.A. Wheeler, B.T. Murray, R.J. Schaefer, Computation of dendrites using a phase-field model, Physica D 66 (1993) 243-262.

DOI: 10.1016/0167-2789(93)90242-s

[4] A.A. Wheeler, W.J. Boettinger, G.B. McFadden, Phase-field model for isothermal phase transitions in binary alloys, Phys. Rev. A 45 (1992) 7424-7439.

DOI: 10.1103/physreva.45.7424

[5] A.A. Wheeler, W.J. Boettinger, G.B. McFadden, Phase-field model of solute trapping during solidification, Phys. Rev. E 47 (1993) 1893-(1909).

DOI: 10.1103/physreve.47.1893

[6] B. Nestler, A.A. Wheeler, Anisotropic multi-phase-field model: Interfaces and junctions, Phys. Rev. E 57 (1998) 2602-2609.

DOI: 10.1103/physreve.57.2602

[7] D. Danilov, B. Nestler, Phase-field modelling of solute trapping during rapid solidification of a Si-As alloy, Acta Mater. 54 (2006) 4659-4664.

DOI: 10.1016/j.actamat.2006.05.045

[8] V.G. Lebedev, E.V. Abramova, D.A. Danilov, P.K. Galenko, Phase-field modeling of solute trapping: comparative analysis of parabolic and hyperbolic models, Int. J. Mat. Res. 101 (2010) 473-479.

DOI: 10.3139/146.110297

[9] I. Steinbach, L. Zhang, M. Plapp, Phase-field model with finite interface dissipation, Acta Mater. 60 (2012) 2689-2701.

DOI: 10.1016/j.actamat.2012.01.035

[10] L. Zhang, I. Steinbach, Phase-field model with finite interface dissipation: Extension to multicomponent multi-phase alloys, Acta Mater. 60 (2012) 2702-2710.

DOI: 10.1016/j.actamat.2012.02.032

[11] Information on http: /www. met. kth. se/~bosse/BOOK/databases/cost507B. TDB.

[12] B.C. Larson, J.Z. Tischler, D.M. Mills, Nanosecond resolution time-resolved x-ray study of silicon during pulsed-laser irradiation, J. Mater. Res. 1 (1986) 144-154.

DOI: 10.1557/jmr.1986.0144

[13] B. Vinet, L. Magnusson, H. Fredriksson, P.J. Desre, Correlations between Surface and Interface Energies with Respect to Crystal Nucleation, J. Coll. Int. Sci. 255 (2002) 363-374.

DOI: 10.1006/jcis.2002.8627

[14] G. Erdelyi, K. Freitag, G. Rummel, H. Mehrer, Volume and grain boundary diffusion of implanted 113Sn in Aluminum, Appl. Phys. A 53 (1991) 297-302.

DOI: 10.1007/bf00357191

[15] P.M. Smith, M.J. Aziz, Solute trapping in Aluminum alloys, Acta Mater. 42 (1994) 3515-3525.

DOI: 10.1016/0956-7151(94)90483-9

[16] L. Zhang, E.V. Danilova, I. Steinbach, D. Medvedev, P.K. Galenko, Diffuse-interface modeling of solute trapping in rapid solidification: Prediction of the hyperbolic phase-field model and parabolic model with finite interface dissipation, Acta Mater. 61(2013).

DOI: 10.1016/j.actamat.2013.03.042