Search results

In this relation the use of cements with low water requirement in the technology of precast reinforced concrete structures which are produced from hard mixtures will be ineffective.
Serdyuk, Low water requirement binders as new generation cements, 10th International Congress on the Chemistry of Cement, Goteborg, Sweden, 1997

ZnS-Intercalated Montmorillonite: A Low Cost Potentiometric Sensor aSiriphorn Udkhao, bAtchana Wongchaisuwat, cLadda Meesuk* Department of Chemistry, Faculty of Science, Kasetsart University, Bangkok, Thailand ag5314400073@ku.ac.th, bfsciatw@ku.ac.th, cfscildm@ku.ac.th Keywords: Montmorillonite, Potentiometry, ZnS, Sulfide ion Abstract.
Montmorillonite, a smectite clay mineral, has a 2:1 layered silicate structure.

Mrowec1,d 1University of Science and Technology, Faculty of Materials Science and Ceramics, Department of Solid State Chemistry, al.
The dramatic positive influence of yttrium on the oxidation rate of the X33CrNiMn23-8 steel is reflected by a different morphological structure of undoped and yttrium doped material (Fig. 7).

Plasticized and Nanofilled Poly(lactic acid) Nanocomposites: Mechanical, Thermal and Morphology Properties Buong Woei Chieng1,2, a *, Nor Azowa Ibrahim1,2,b , Yoon Yee Then1,c and Yuet Ying Loo3,d 1Department of Chemistry, Faculty of Science, Universiti Putra Malaysia, 43400 UPM Serdang, Selangor, Malaysia 2Materials Processing and Technology Laboratory, Institute of Advanced Technology, Universiti Putra Malaysia, 43400 UPM Serdang, Selangor, Malaysia 3Department of Food Science, Faculty of Food Science and Technology, Universiti Putra Malaysia, 43400 UPM Serdang, Selangor, Malaysia achieng891@gmail.com / chieng@upm.edu.my, bnorazowa@upm.edu.my, cyoonyeetyy84@yahoo.com, dyuet_ying88@hotmail.com Keywords: graphene nanoplatelets, plasticizer, poly(lactic acid) Abstract.
Graphene combines layered structure of clays with superior mechanical and thermal properties of carbon nanotubes, which can provide excellent functional properties enhancements [4].

Changes in the height of peak located in the range 0.6 – 2 nm indicate changes in the porous structure of the activated carbon, in particular the formation of new micropores.
The chemistry of the surface was investigated by Scanning Electron Microscopy/Energy Dispersive Spectroscopy method (not presented hire).

Moreover, polymer matrix will not experience in dynamic conformational changes [16] and Li+ ions might be migrates through the conduction path formed by the lattice structure of CA chains.
Watanabe: The Journal of Physical Chemistry B118, (2014) 5144-5153 [12] M.R.

Perovskites are a family of materials with a specific crystal structure with chemical formula of ABX3 [6].
Li, Semi-transparent perovskite solar cells: unveiling the trade-off between transparency and efficiency, Journal of Materials Chemistry A, 6 (2018) 19696-19702

Present research focuses on the influence of sintering temperatures to the mechanical properties and microscopic structure of the TiN/Si3N4 composite.
Experiments The powder of Si3N4 used in the experiment were synthesized by Self-propagation High temperature Synthesis( SHS) Method(from Technical Institute of Physics and Chemistry, CAS), with purity > 97% (mass fraction, the same below), α phase content > 70%.

However, considering that slight discrepancy is observed at 0.25 microns, it is an intriguing area of research to expand the study to incorporate ultra-thin polymeric films (< 0.1 microns), especially when the approaching length scales are similar to that of the polymer coil size, since the thinner structure is highly sought after in membrane gas separation application.
Royal Society of Chemistry, Cambridge, 2011, pp. 58-83. [2] T.

Ferro 3) 1 Institute of Materials Science and Applied Research, Vilnius University, Sauletekio Ave. 9-3, LT-10222 Vilnius, Lithuania 2 Department of Physics, Chemistry and Biology, Linkoping University SE-581 83, Linkoping, Sweden 3 Laboratoire des Multimatériaux et Interfaces, UCB Lyon I, 43 Bd du 11 novembre 1918, 69622 Villeurbanne, France a kestutis.jarasiunas@ff.vu.lt Keywords: carrier lifetime, diffusion coefficient, mobility, carrier scattering.
This structure behaves as a diffraction grating, and its dynamics was monitored by diffraction of a delayed probe beam at 1064 nm for various grating periods Λ.