Search results

Full length of each RNEF brand was ultrasonically cleaned in 99% ethanol, dried and mounted on Al plate for surface morphology examination with SEM (JEOL JSM-820).
Information on http://www.aae.org/uploadedFiles//Publications_ and _Research/Endodontics_Colleagues_for_Excellence_Newsletter/winter08ecfe.pdf [3] A.L.
El-Mahallawi: Engineering Failure Analysis.
El-Mowafy, B.Tompson, and B.
Al-Shalan, Z.

Zhu Jungao et al. firstly put forward the concept of foundation isolation; Liu Xiaoli et al. conducted study on the impact of gravel cushion thickness and base pressure on the ground seismic response; Dou Mingyuan, Zhao Shaowei, Liu Darong et al. researched the impact of such factors as cushion thickness and particle size on the performance of seismic isolation through the shaking table test of gravel cushion.
Fig.9 is the comparison chart of the output accelerations of upper and lower concrete slabs vs. the input acceleration of shaking table under the action of El Centro-wave 800gal earthquake.
[4] Yang Qing, Luan Maotian et al., Indoor Experimental Study on Horizontal Anti-sliding Performance of Roof-Concrete Floor and Gravel Cushion [J].
[5] Shang Shouping, Zhou Zhijin et al., Performance of a Reinforcement-Bitumen Compound Seismic Isolation Layer [J].
[6] Mao Shangli, Yu Xiangjuan et al., Mechanism Study on Seismic Isolation and Reduction of Foundation [J].

Kengkhekit et al. [8] proved that the PALF can be effectively used as a reinforcing agent in the polypropylene matrix.
Zhao et al. [11] evaluated the effect of sisal fiber loading on the mechanical properties of HDPE.
El-Shekeil et al. [12] reported that the composite of 30% kenaf fiber content in the polyurethane matrix yields the maximum value of tensile strength than the other composition.
Zahari et al. [14] studied the effect of fiber loading on tensile properties of Ijuk/PP composites.
El-Shekeil, S.M.

Proof: See the proof of Wang et al. [6].
Proof: See the proof of Wang et al. [6].
Proof: See the proof of Wang et al. [6].
Following Xiang et al. [4], if , we denote .
Graham, E.L.

King et al[5] reported dilute sodium hydroxide as the condensing agent in yield of 78%.
New et al.[6] reported ammonium acetate and acetic acid as the catalysts in yield of 60%.
In 2004, Soong-Jin Hong et al.[7] reported that sodium acetate and methylamine hydrochloride can serve as excellent catalysts for such a reaction with mild reaction temperature and short reaction time in yield of 83%.
Mandal, et al: J.
S, Dahiya R, Kumar S: Tetrahedron Lett., Vol. 38(1997), P. 5131 [9] Abdallah-El Ayoubi S, Texier-Boullet F, Hamelin J: Synthesis, (1994), P. 258 [10] Pelle Lidström, Jason Tierney, Bernard Wathey, et al: Tetrahedron, Vol. 57(2001), P. 9225 [11] Olivier Correc, Karine Guillou, Jack Hamelin, et al: Tetrahedron Lett., Vol.45(2004), P. 391 [12] Jose M.

Moreover, Gerc-el et al (2002) observed that the highest liquid yield is at 25-50ml/min and by increasing the gas velocity lead to lower liquid yield [7].
Furthermore, Ays¸e Eren Pu¨tu¨n et al report in 2007, the liquid yield decreased when the gas flow rate increased from 100ml/min to 400ml/min [8].
[7] Gerc-el HF.

This is achieved by fitting the silicon elemental concentration data to the Douglas and El Shamy equation [3] , where Q is the [Si] in solution after immersion time t, K is the rate constant and γ KtQ = γ is the exponent.
El Shamy: J.
Xynos et al.: Biochem. and Biophys.
Xynos et al.: J Biomed.

Recently, Zhao et al. reported the synthesis method for single-crystalline rutile TiO2 nanorods on the fluorine doped tin oxide (FTO) substrate using the hydrothermal method , and they studied the influence of growth time and annealing on the structures were they employed to fabricate dye-sensitized solar cell (DSSC) [17].
Vishwas at el. studied the Influence of annealing temperature on Raman and photoluminescence spectra of TiO2 thin films that were deposited on fused quartz substrates by electron beam evaporated [18].
Xia at el. fabricated TiO2 nanostructures with high quality by direct annealing of the Ti foil with Pd catalyst [19].
In the visible region, TiO2 demonstrated two dominant PL emissions centered at around 519 and 705 nm (Fig.4). were stabilized These emissions were the radiative recombination of the self trapped excitons and the radiative transitions inside the substrate transitions inside the substrates initiated from the TiO2 surface [24].This result well agreed with those reported by Vishwas et al.[25] 4.

Fabrication using Focused Ion Beam Processing of Devices Employing Silicon-Based Nanowires Synthesized by Vapor-Liquid-Solid Growth Hayato Sone1,a, Yousuke Nakamura2, Yasuyuki Suda3 and Sumio Hosaka1, b 1Division of Electronics and Informatics, Faculty of Science and Technology, Gunma University, 1-5-1 Tenjin-cho, Kiryu, Gunma 376-8515, Japan 2Department of Production Science and Technology, Graduate School of Engineering, Gunma University, 1-5-1 Tenjin-cho, Kiryu, Gunma 376-8515, Japan 3Department of Production Science and Technology, Faculty of Engineering, Gunma University, 1-5-1 Tenjin-cho, Kiryu, Gunma 376-8515, Japan asone@el.gunma-u.ac.jp, bhosaka@el.gunma-u.ac.jp Keywords: Si-based nanowire, vapor-liquid-solid growth, VLS, focused ion beam, FIB, nanowire device, current-voltage characteristics, boron doping Abstract.
Zhang et al. reported using silicon nanowire biosensors that were highly sensitive and enabled rapid detection of the Dengue virus [10].
Characterization and application of quasi-one dimensional metal oxide semiconductors for use as chemical sensors have been studied by many researchers, and these semiconductor-based chemical sensors have been reviewed by Comini et al. [12].

El-Ghannam, Synthesis and characterization of a novel SCPC-CO3Ap cement for pulp capping application in dentistry, Key Eng.
Al-Jamie, H.
Freire, A.P.L De Carvalho, E.L.
Gritti, et. al., The influence of dentine on the pH of calcium hydroxide, chlorhexidine gel, and experimental bioactive glass-based root canal medicament, The Scientific World Journal. (2015) 1-5