Search results

Measurements and literature data agreement with these model predictions was good enough to allow their integration into commercial solidification codes for microstructure prediction.
This may have contributed to the reduction in grain size.

Salinity caused significant reduction in germination percentage, germination rate in sugar beet [3, 4].
Statistical analysis: Data of final seedling emergence, total seedling emergence, shoot and root dry weights, Na+ and Cl- concentrations in leaves of two cultivars were subjected to a two-way ANOVA using the SAS™ software [11].

In Fig. 6 the results show that with the reduction of lap length, the length from the upper joint position of hydraulic cylinder to the boom head become large and large, as well as, the additional bending moment increase fast, the extreme stress of the boom structure is large enough led to yielded state.
Using a single variable and keeping the other three variables unchanged method, after a series of calculation and process of the data, the results are shown in Fig.7.

The ability of the oxidation-reduction of Dawson type molybdophosphoric heteropolyacids is stronger than that of keggin type molybdophosphoric acids[12].
The data shown in the bottom row of Table 1 were the difference between the maximum and minimum values among the three rows.

Furthermore, recent data also suggest it can increase cancer risks and mortality.
Cell metabolism, absorption transport of surface biological macromolecules, biosorption, biological precipitation reaction, biological oxidation and reduction reaction are the main repair mechanisms of bioremediation.

In addition, the dislocation structure developed during the plastic straining will also gradually change during artificially ageing due to static recovery processes, which leads to a continuous reduction in the overall dislocation density.
Note that the measured data points represent different storage times ranging from 1 minute up to 10 weeks.

ARB processing consisted in the repetition of 5 steps: i) degreasing in 4-chlorethylene and wire-brushing with stainless steel 0.3 mm wire brush; ii) stacking of pieces of 300×50×2 mm 3; iii) joining by Al wires; iv) heating to 200, 250, 300 and 350°C, respectively; v) rolling with 50% reduction without lubricant.
The application of the two-state trapping model [5] to the data reveals that dislocations in ARB samples are distributed non-homogeneously, i.e. they are arranged in cell or subgrain boundaries.

The greater initial flux the more permeable membranes had more severe flux reduction.
It is noteworthy that porosity parameters obtained can vary as a consequence of fitting experimental rejection data with different transport models and for different tested solutes.

One contribution to counteract this vicious circle is the reduction of the car bodyweight [1].
Thus, knowledge of the temperatures [5] as well as temperature dependent material data is required.

For the penetration depth of 300 µm there was full contact between punch and sheet but no reduction of the sheet thickness was intended.
Material data were obtained by layer compression test and a friction coefficient µ = 0.19 according to Thome [15] was chosen.