Search results

TiO2 is largely used in wastewater treatment because many organic compounds can be decomposed and mineralized by the proceeding oxidation and reduction on TiO2 surface [2].
Sample %degradation kinetics data k (min-1) R2 t1/2(min) Without surfactant 99.35 10x10-1 0.9996 69 TritonX-100; 0.5 99.50 11x10-1 0.9972 63 TritonX-100; 1 99.32 20x10-1 0.9963 34 TritonX-100; 2 99.24 11x10-1 0.9954 63 TritonX-100; 3 98.73 10x10-1 0.9946 69 TritonX-100;4 98.73 7 x10-1 0.9883 99 In conclusion, all TiO2 thin films were obtained by dip-coating borosilicate glass into TiO2 sol-gel, which was modified by TritonX-100 surfactant.

According to the Line Weaver–Burk transformation of the data, Eq. (1) is obtained as follows: (1) In this work, the speed of enzyme reaction is accordingly showed as the value of ΔF; Eq. (2) is obtained: (2) So, the plot of 1/ΔF versus 1/[OXDP] was used, as shown in Fig.5.
Synthesis of disodium salt of 2-(5-phenyl-1, 3, 4-oxadiazol-2-yl) phenyl phosphate Fig.1 Fluorescent emission spectrum of OXD Scheme 2 Dependence of normal and tautomer Emission on OXD Fig.3 Fluorescent emission spectrum of OXDP +ALP Scheme 3 Principle of fluorescent determination of ALP using OXDP as a substrate Fig.4 Effect of OXDP concentration on fluorescence intensity reduction Fig. 5 The Line Weaver–Burk linearization Table 1 Determination of ALP activity in human serum samples Sample Colorimetric Detn (U/L) Fluorimetric Detn (U/L) Relative error (%) Found RSD(n=3) 1 71.5 72.6±1.14 0.93 101.5 2 53.8 54.1±2.09 2.29 100.6 3 35.6 36.1±1.99 3.27 101.4 4 97.6 99.1±1.94 1.16 101.6 5 44.6 46.4±1.85 2.36 104.1

After charging the capacitors of each zone have been discharged through the sensing resistors while the voltage gradients were measured by a data logger.
Third, a noticeable reduction of the energy yield is caused by the electrical circuitry consuming energy for its own function.

Fig. 1 is Si-O-N stable phase diagram at 1873K obtained in terms of relevant thermodynamic data[6].
The decline in bulk density is predominantly because the bulk density of silicon powder is lower than that of corundum, while the reduction in apparent porosity shows that silicon powder has contributed to sintering.

On the other hand, excessive metal oxide cations of the D shells( such as Fe2+, Ni2+ and Mn2+ .etc.) easily loses or gains electrons, which has a strong ability in oxidation and reduction .It's empty D and F orbital function with lone pair electrons and produces inductive effect.
So, the variation of the data illuminated that the amounts of Nickel sulfate adding to Zirconium sulfate had an great effect on its catalytic activity and the optimal adding the amount of Nickel sulfate was 1.0g.

The spectroscopic data were listed below for the three-benzene-ring bent-core compound N,N-bis (4-propoxybenzylidene)benzene-1,3-diamine: 1HNMR (500 MHz, CDCl3, d/ppm): 8.50 (2H, s, 2CH=N), 7.00-7.65 (12H, 12Ar-H), 4.05 (4H, t, 2OCH2), 1.05 (6H, t, 2CH3), 1.13-1.94 (24H, 12CH2).
The reduction of the nucleating sites should result in a larger single crystal.

At the same time, another apparent phenomenon that is the reduction of ISDs of the strengthened and transfer stories becomes obvious greatly with the increase of the development of plastic hinges.
From the above data, the maximum tensile stress of shear wall is greater than the design value of tensile strength of concrete (2.04 Mpa, C60), which demonstrates that the concrete of the first floor shear wall has produced cracks under RIEs.

Table 2 PV costs down quickly Item 2007 2008 2009 2010 2011 2012 System price (Yuan/Wp) 60.0 50.0 35.0 25.0 17.5 10.0 Component life 20 25 25 30 30 >30 PV electricity prices (Yuan/KWH)(Ⅲ) 4.20 4.00 2.50 2.00 1.15 1.00 Note: Price data of PV electricity come from the third radiation zone.
Under the CDM circumstance, the income of carbon emissions reduction (CER) of PV system should be considered [5].

A greater reduction in the droplet size requires a great amount of mechanical energy.
The data showed that up to 80% heat transfer enhancements could be obtained with concentrations aslow as 1%.

The advantages of Ga-graded obtained by growth profile modification and Na incorporation on Cu(In,Ga)Se2 solar cells Rachsak Sakdanuphab1,a, Sojiphong Chatraphorn2,b and Kajornyod Yoodee2,c 1College of Data Storage Innovation, King Mongkut’s Institute of Technology Ladkrabang, Bangkok, 10520 Thailand 2Semiconductor Physics Research Laboratory, Department of Physics, Faculty of Science, Chulalongkorn University, Bangkok, 10300 Thailand aksrachsa@kmitl.ac.th, bsojiphong.c@chula.ac.th, ckajornyod.y@chula.ac.th Keywords: Cu(In,Ga)Se2; band gap grading; Ga-Graded; solar cell.
It assists in sweeping electrons in the quasi-neutral region of absorbers across the junction, resulting in the increase of the minority carrier’s life time and diffusion length as well as reduction of the recombination [6].