Search results

Due to the possibility of heat accumulation in high friction coefficients and increasing the probability of error during problem analysis, in the present study, a reduction model for the coefficient of friction has been used.
Ref. data, 13 (4) (1984) [21] D.

Reduction of lattice thermal conductivity leads to an increase in ZT value.
Availability of Data And Material Not applicable since no datasets were used in this research.

Thus, the reduction of cement consumption has an ecological as well as an economical advantage.
Figure III Experimental set up of DIC technique with CT specimens In this study, three steps were followed when applying the Digital Image Correlation technique : preparation of specimens, acquisition and analysis of data.

Mathematical Model To design the wind turbine, it is essential to know the input data and the required output.
“Reduction of Aircraft Tyre Wear by Pre-Rotating Wheel Using ANSYS Mechanical Transient.”

This study also takes the lifespan of external insulation materials into consideration, while the extra energy consumption due to the external insulation performance reduction during the building operation phase is ignored. 3) Disposal phase.
Meanwhile, this building is still in use, so the data of disposal phase couldn’t be obtained.

To overcome the low solution problem most acceptor dopants faced, Yamamoto et al. has put forward an “codoping method” [20], it means doping group Ⅲ and group Ⅴ elements such as Al and N simultaneously, they found that one of the reasons for the difficulties of preparing p-type ZnO thin films is the change of madelung energy [20], the higher the madelung energy is ,the more instability the film is, for ZnO thin films, while n-type doping could decrease the madelung energy, p-type doping could increase the madelung energy, but when codoped acceptors and donors into ZnO at a concentration ratio of 1:2, the madelung energy would be largely decreased, besides, this method is very important for the enhancement of the solubility of the acceptors by the stabilization of the ionic charge distributions and the reduction of acceptor binding energy, and because of the interactions of donors and acceptors, the donor level will become higher and the acceptor level will become lower just like Fig. 2,
Saxena, Handbook of atomic data, first ed., Elsevier, Amsterdam, 1976

When oxidation occurs (also referred as "doping"), ions from the electrolyte are transferred to the polymer backbone, and upon reduction ("dedoping") the ions are released back into the solution.
Since the specific performance of the C/C composites could be as well attributed to a sufficiently developed surface area, the porous texture data determined by nitrogen adsorption at 77 K for the different composites prepared at 700°C were compared to the characteristics of the single components (CNTs and carbonised PAN).

Economical evaluation has been performed using the following main input data on prices (identical for all alternatives) at level of I/2012 year: - Price of sold heat 13.278 Euro/GJ - Price of electricity sold to the network: 195.844 Euro/MWh - Price of water from geo-source 0.03 Euro/t - Price of transfer medium 0.89 Euro/t - Labour costs 1500 Euro/month.man - Annual price increase 3 % - Discount rate 7 % Investment Costs Investment costs have been calculated for project implementation by one general turn-key supplier.
"HDR Reservoir Flow Impedance and Potentials for Impedance Reduction" Proceedings, 18th Workshop on Geothermal Reservoir Engineering, Stanford University, Stanford, CA (1993) p. 193-197

In the table, the following symbols are adopted: fmd0, compressive strength of unconfined masonry; fmd, compressive strength of confined masonry; fl, total confining lateral pressure; f’l, effective confining lateral pressure; gm, masonry density; D, diameter of the circular cross-section or diagonal of the polygonal cross-section of the column; fc,mat and tmat, compressive strength and thickness of the mortar matrix in FRCM systems; Ψf, reduction factor.
The results are reported for all models together with the experimental data.

When compared with models of that time using the extremum criterion, the new theory gave a reduction of the growth velocity of nearly one order of magnitude and this corresponded well with the experimental findings.
Experimental data for ice from Fujioka and for succinonitrile from Glicksman et al. [25].