Search results

The data, obtained in triplicate, were evaluated by the Bluehill and Origin-8 programs with calculation of hysteresis, by the maximum difference between the advancing and receding angles.
According to Way et al., the incorporation of natural cotton fibers (25 wt%) without chemical treatments resulted in strengthening the polymeric matrix, and promoted a reduction of the crystallinity [17].

According to research, it has been demonstrated that when truncated, these infinite periodic layered media or photonic bandgap (PBG) materials can support Tamm states or Bloch surface waves (BSW) [21–25], and thanks to the conversion of invisible biological data into simple optical signals that are easy to measure, it is possible to manufacture optical biosensors whose performance depends on several parameters such as : sensitivity [26,27], detection limit [28], quality factor [29,30] and the figure of merit [25].
The obtained FOMs increase from 1101/RIU to 1545/RIU when moving from w.d/c=2.4 to w.d/c=2.6 but drop to the value of 1295/RIU for w.d/c=2.8. this decrease is caused by the reduction of 1-MRR because the FOM is proportional to it.

The variation in wind speed led to a reduction in the power at the generator output from 11.7kW to 700W.
Pallaï, Report of the mission to collect experimental data from the cities of AMDJARAS and FADA, Scientific report on field mobility, N’Djamena, (2022)

Actually it is very likely to even surpass Power Generation, where a lot of efforts in decarburization and reductions through Energy Efficiency improvements are on their good way.
[13] IEA Data 2009 [14] Prof.

And, with a view to getting high accuracy in modelling, and fast response the data obtained from the sliding mode controller have been used as a teacher in two separated Adaptative Network Fuzzy Inference System controller.
The advantage of backstepping over other control methods lies in its flexibility of applications, including Lyapunov-based design, reduction of high-order model to several first-order subsystems, and stability guarantee.

It is generally accepted that TiO2 can generate electron-cationic holes under illumination, which promotes oxidation and reduction reactions at the solid surface [7, 8].
The diffraction patterns (data not shown) also imply the formation of TiO2 nanostructures with good crystallinity.

However the possibility of reaching elongations higher than 200% can bring to significant cost saving benefits: in particular complex shape components can be manufactured without any joint with a weight reduction and an improvements of its mechanical behaviour [1].
Zhang: Material modelling data for superplastic forming optimization, Materials Science and Engineering A 410-411 (2005) 100-104

INTRODUCTION According to data from the statistics of the largest companies in the world and the only global non-governmental organization dealing with the management of secondary raw materials, the Bureau of International Recycling based in Brussels, secondary raw materials industry annually uses 700 - 800 million tons of secondary raw materials (i.e. more than 40 % of all materials used in industry) with an annual turnover of about 170 trillion $ [1].
§ Size reduction in high-speed forced-action mixers to polyurethane grain size of 6 mm.

The algorithms of this paper will discuss the difference in these two data structures.
We check the correctness of syntax and get the syntax tree using total control procedures of the LR analysis method by bottom-to-up reduction.

Better thermal insulation properties, which are achieved, among others, by increasing the air content in concrete mixtures (i.e. by increasing the porosity of the material, in particular under the condition of a relative reduction of material-thermal parameters and strength) are the desired properties of innovative types of light-weight concrete.
GUM: Evaluation of measurement data--Guide to the expression of uncertainty in measurement, Paris: BIPM.