Search results

Furthermore, the effect of rare earth metal Y3+ doping on Ce2S3 was investigated by XRD data.
The Y doping creates surface strain due to an increase in the number of surface atoms causing reduction in the crystallite size and an increase in oxygen concentration due to local strain occurring in the core of the NPS.

The main and priority objectives for the development of space solar cells are the improvement of conversion efficiency, weight reduction and better resistance to radiation.
Ismail, "Role of facile synthesized v2o5 as hole transport layer for cds/cdte heterojunction solar cell: validation of simulation using experimental data," Superlattices and Microstructures, vol. 132, p. 106168, 2019

Very high thermo-electrical performance, being competitive with that of Bi3Te4, was reported by Terasaki et al. [19] Takada et al. [20] discovered that the γ-Na0.7CoO2 transformed to the superconducting Na0.3CoO2 ·1.3H2O after the reduction of sodium content down to Na0.3CoO2 and addition of H2O.
Based on the single-crystal X-ray diffraction data, Leligny et al. [34] analyzed the Bi-system, [Bi0.87SrO2]2[CoO2]1.82, assuming the (3+2) dimensional space symmetry of I2/a(α 0 γ, 0 μ 0) pmm, with modulation vectors q11=0.293(2)a11*+0.915(9)a13* and q12=1.8204(5)a12*.

The objective of voltage deviation reduction is to minimize total voltage margin in load buses (PQ buses), whereas the goal of voltage stability enhancement is to minimize the upper index term of voltage stability.
The element which has the best fitness function is selected for the next generation t+1 under the following equation: (22) Application of ESCA to ORPD Problem The principal steps OF ESCA for solving the ORPD problem are listed as follows: Step 1: Read the parameters of the group np, tmax, nd: the number of control variables U of proposed solution problem and all data of power system.

Then, a four high pilot cold rolling mill was used to cold-roll the hot-rolled strips to the final thickness of 0.5 mm with a total reduction of 81%.
Fig. 3 Number density and size distribution of non-metallic inclusions with different RE contents in the slabs The statistical datum shows number density of the inclusions in the inner samples which size is in the range of 0.05μm~1.0μm are 33×104 /mm3 and 17.5×104 /mm3 when the content of RE in the steel bearing 1.15 wt% Si is 60×10-4 wt% and 100×10-4 wt% respectively.

Gap control In order to derive the system’s equation, the following symbols are used: - s = Position of edge of exotic material (mm) relative to pre-erosion datum - A = Cross sectional area of PCD (mm2) - = Mass removal rate (kg/s) - r = Density of exotic material (kg/mm3) - e = Gap (mm) - f = Actual feedrate (mm/s) - V= Average gap voltage (V) From Fig. 2, the mass removal rate is measured by the movement of the edge of the exotic material: (1) (2) (3) Where f is the feedrate function depending on gap voltage.
It is therefore important to monitor the reduction in dielectric strength of the oil to ensure that experimental results take into account this variable.

It is expressed as a percentage reduction in pregnancy rate for a single use of emergency contraception.
[5] http://www.searo.who.int/entity/health_situation_trends/data/mnch_unmet-needs-of contraceptives / en/

From this data, it can be inferred that using immiscible polymer blend promoted segregation of conductive particles into a confined volume, leading to more conducting pathways.
Hence, reduction in thickness of graphite platelets will result in larger specific surface area and higher aspect ratio.

Macromolecules comprising anticancer receptors MMP9, MMP2, CCNA2, P53, and BAK, EGFR, ADPRP (PDB ID: 4H1Q, 3AYU, 2V22, 2VUK, 6UXM, 1U0K, 5HG7 respectively) were retrieved from the Protein Data Bank (PDB).
Lockhart et al., Reduction of wound angiogenesis in patients treated with BMS-275291, a broad spectrum matrix metalloproteinase inhibitor.

Adding anthraquinone into the soda pulp led to an increase in screen pulp yield, a lower lignin content, increase energy efficiency, and a reduction in rejects [23, 26, 27].
This graphical figured out the data values in table 1 for different biomass resource (banana pseudo stem, wheat straw, eucalyptus labill, Enset Ventricosum stem and bagasse).