Search results

Fig. 7 (a) Rietveld fit (red graph) to XRD data points (black circles), for orthorhombic PbNb2O6, with their difference shown by the continuous curve in the smaller-sized graph.
So, there are no data on operational experience.
In USA, three-dimensional images were obtained [89] by rotating the eight transducer linear array (Fig. 13) through an arc and using time-of-flight data to derive the depth dimension.
Data on the temperature dependence of dielectric, piezoelectric and electromechanical properties are, however, rather limited.
Will, Powder Diffraction: The Rietveld Method and the Two Stage Method to Determine and Refine Crystal Structures from Powder Diffraction Data, Springer-Verlag Berlin Heidelberg, 2006

The importance of the thermal spike model has been evaluated by the development of the model to account for the problem of defining temperature under the non-equilibrium conditions in the spike, together with the availability of new experimental data [91].
A reduction of about 50% is obtained with 300 keV proton and argon ions, having 300 keV energy, at a dose of about 1014 and 1013 ions/cm2, respectively [125].
The enhancement in antioxidant activity of PAni nanofibers was associated with the reduction in their size and corresponding increase in their surface to volume ratio.
The reduction in the nano-cavities of the polymer upon thermal and ion beam treatment can be determined using positron annihilation techniques [109]. 4.2.2.
Since hydrogen is the lightest gaseous molecule, it can easily diffuse and escape from the polymer bringing about a reduction in the hydrogen content in the polymer due to ion irradiation.

., hundreds of grams of materials being required, with an exposure time of approximately one minute [34] and the data analysis was time consuming.
Despite this technique having been used extensively in the past, only low reduction spectra (5-10nm) have typically been recorded due to the relatively time consuming data collection and the small signal intensity at high resolution.
Fig. 11 (b) Plot of log I versus (t-tm) for ZnS:Mn nanoparticles for the ML induced by application of pressure of 500N (Plot on basis of data given in Fig.11(a)-I).
[42] P.Jha, B.P.Chandra, Impulsive excitation of mechanoluminescence in SrAl2O4:Eu, Dy phosphors prepared by solid state reaction technique in reduction atmosphere, J.

Even the lower bound of the reduction of Ees by free electrons/holes in §1.2.4 (~ 20 %) is significant in comparison with the free energy difference of ferroelectric and paraelectric phase, because this difference is a small fraction of Ees.
A similar calculation shows that the reduction is more than 50% near the surface.
The experiments of M/F/I/S and M/F/S (§1.4.7) can be viewed as invaluable data for the ferroelectric basics, because the direct measurements of the electrostatic charge induced by PS are difficult by other experiments.
(d) Theoretical Q vs. lf for different lI with experimental data shown by arrows.
The data points in (d)(h) and (i) are obtained by IV characteristics (e.g., Fig. 21(c)) and I-t (current -time) characteristics (e.g., Fig. 21(e)), respectively.

Concerns about the data's comparability arise when the standard deviation is 2.00.
When evaluated to the ranges of the Tensile SS, bonding performance could not explain the reduction.

The mitigation of energy depletion and gas releases as an utmost significance worldwide is a renowned datum; which also needs the improvement of delicate substances employing budget-proficient and ecologically pleasant methods.
MT is divided based on textiles, substance manipulation, substance transformation, and data communication [5].
In melting, the foundational substance is liquefied lightly, though the main source of energy input goes into the chemical directing at a small reduction.

ICP results confirmed the SEM observations (data not shown). 0 days 3 days 21 days Figure 3.
After 7 days of immersion in SBF there is no formation of a Ca-P layer on unfilled SEVA-C surface (data not shown).
The Ca/P ratio for the apatite formed on an UV radiation treated surface after 6 hours of nucleation is 1.23 (data not shown).
TF-XRD data obtained for these samples clearly match the standard XRD hydroxyapatite pattern (JCPDS 09-432 standard file).
Again, TF-XRD data confirms that Ca-P films are mainly apatite-like.

Mechanical property Value Poison’s Ratio 0.3 Elastic Modulus (G Pa) 207 (G Pa) Ultimate Tensile Strength (MPa) 996.7 (MPa) Yield Strength (MPa) 675.7 (MPa) Percentage reduction of area 4.22 Percentage Elongation 3.09 Table 3 CAD assembly’s mechanical properties.

In 1995, Yeong-Bin Yang et al [6] used the concept of the vehicle-bridge coupling unit to put forward the Dynamic Reduction method which enhanced the computational efficiency and could be applied to simulate the situation where many vehicles with different speed crossed the bridge in both directions.
[15] Ton-Lo Wang, Chunhua Liu, Dongzhou Huang, Mohsen Shahawy, Truck Loading and Fatigue Damage Analysis for Girder Bridges Based on Weigh-in-Motion Data, Journal of Bridge Engineering, ASEC. 10(1) (2005) 12-20