Search results

The finding obtained in this work is not in agreement with the finding of Brandão et al. [7] who reported a reduction in Deff-values with an increase of the non-heated air velocity in the hybrid drying of pollen grains.
El-Abdein, Kinetics and mathematical modeling of infrared thin-layer drying of garlic slices, Saudi Journal of Biological Sciences, 25 (2018) 332-338

References [1] Al-amiery, A.
[7] Hamdy, A., and El – Glendy, N.

The valence analysis was carried out by XPS (Kratos Axis Ultra DLD, Japan) with monochromatic Al-Kα radiation as the excitation source.
El-Shall, Laser Synthesis of Pt, Pd, CoO and Pd-CoO Nanoparticle Catalysts Supported on Graphene, Chem.

Wright and A.L.
[23] Wang, S., Alenius, H., El-Nezami, H. and Karisola, P., 2022.

This data is also supported by Drabik et al. [15] that predicted a continuous increase in demand with possible growth to 900 GWh by 2026.
According to Lu et al [45], the optimum condition for battery discharge is to use a 1% (w/w) concentration of NaCl solution for 70 minutes.
Table 2 shows that the experiment conducted by Kim et al [79] is the best when viewed from the H2SO4 waste treatment.
Table 2 indicates that the experiment with the lowest heat energy was carried out by He et al [77] with a temperature value of 40 oC.
El-Khateeb, Acid leaching of mixed spent Li-ion batteries, Arab.

Zhang et al., 2021 also doped TiO2 with a mixture of Co and Eu.
Shirazi et al., 2017 doped Al on ZnO so that it could help reduce the charge recombination.
The P atom and B atom doping were explained by Hu et al.
Al-Sehemi, H.
El Cohen, L.

Somashekar et al. [13] have pointed out that the capacitance is the most significant factor that affects the performance characteristics.
Shichun et al. [14] observed that the open voltage is the main parameter in the kerf width control for improving machining precision.
Saini et al. [15] used the Taguchi method with analysis of variance (ANOVA) to optimize WEDM process parameter while machining a composite material.
Rao et al. [16] used the Taguchi method to determine the optimal set of cutting parameters for better surface roughness in WEDM.
El-Tamimi, and A.

This is particularly true for (Ni, Pt) Al bond coats that do not getter sulfur.
This can be achieved by the use of piezoelectric [67] or shape memory [68] structures, as shown in prior work by Lu et al [69-71], Wadley [72,73] and Hilary et al. [74,75].
Quantitative studies on single crystals of Fe-Cr-Al alloy", Acta Materialia, Vol. 46, No. 14, pp. 5153-5166, 1998
Ritchie, “Resistance-curve toughening in ductile/brittle layered structures: behavior in Nb/Nb3 Al laminates” Materials Science and Engineering, 1996
[89] Ali El-Chaikh, Thomas K.

Grubb et. al. (1994) showed that workload actually was fairly high in tasks where humans must act as monitors over a period of time, as they do with automated systems [42].
[3] Wiener, E.L. (1985).

From the periodic table of the chemical elements is apparent that the appropriate thus seems especially materials based on Be, B, C, Li, Mg, Al, Si and Ti.
El Maihi, S.