Applied Mechanics and Materials
Vol. 421
Vol. 421
Applied Mechanics and Materials
Vol. 420
Vol. 420
Applied Mechanics and Materials
Vol. 419
Vol. 419
Applied Mechanics and Materials
Vol. 418
Vol. 418
Applied Mechanics and Materials
Vols. 416-417
Vols. 416-417
Applied Mechanics and Materials
Vol. 415
Vol. 415
Applied Mechanics and Materials
Vols. 411-414
Vols. 411-414
Applied Mechanics and Materials
Vols. 409-410
Vols. 409-410
Applied Mechanics and Materials
Vols. 405-408
Vols. 405-408
Applied Mechanics and Materials
Vol. 404
Vol. 404
Applied Mechanics and Materials
Vols. 401-403
Vols. 401-403
Applied Mechanics and Materials
Vols. 397-400
Vols. 397-400
Applied Mechanics and Materials
Vols. 395-396
Vols. 395-396
Applied Mechanics and Materials Vols. 411-414
Paper Title Page
Abstract: In this note, we establish a converse comparison theorem for backward stochastic differential equations (BSDEs).
1400
Abstract: A novel quadratic spline Hermite interpolation method for constraining the slope of interpolation curve in a user-defined interval is proposed. The method solves the interpolation problem by dividing point sequence into a series of two adjacent points. By selecting the slopes of these two points skillfully, the slope of interpolated curve can be constrained easily. Then, the entire interpolated curve can be obtained by linking all of these two-point interpolated curves. A series of experiments are carried out to test the performance of these methods. Experimental results show that this method reach expected results perfectly.
1404
Abstract: We present the time-varying critical fertility and analysis the stability of the system at the critical value. Then we get the sufficient conditions about the system stability, asymptotically stability and not. Keywords: Population development system; mortality rates; Critical fertility rate of women; stability
1409
Abstract: By using Delaunay triangulation algorithm, triangulating with split-merge algorithm and the incremental insertion algorithm, improving the judgment that if the new inserted point meets the Delaunay triangulation "empty circle" criterion in synthesis algorithm, meanwhile, with the corresponding improvement of the LOP optimization algorithm, the design of weldment model in the virtual welding system has achieved good result.
1414
Abstract: In this paper the asymptotic stability of global solutions to the initial-boundary value problem for some nonlinear wave equation with nonlinear damping and source terms is studied by using a difference ineauality.
1419
Abstract: In this paper, a small aperture Cassegrain antenna of 8mm band detector is optimally designed, whose main reflector diameter is limited at 96mm (diameter less than 30λ). After design and processing, this antenna measured results show its gain is 26dB, the sidelobe level is close to-12dB and-3dB beam-width is 4.8 °.These are consistent with simulation optimization results.
1425
Abstract: Abstract. A STM32-based embedded system for 3mm wave detector calibration control platform is introduced in this paper. This embedded control system includes noise source control circuit, database circuit, a real time clock circuit, humidity and temperature sensor circuit, PS/2 interface circuit and SD card interface circuit. Experiment results demonstrate that the Embedded system could satisfy the requirement of millimeter wave detector calibration.
1429
Abstract: In the practice ,the transient state decided by the system character is the key of the automation of machine health monitor process. FFT and Wavelet Transform are the well known techniques in this field. We proposed an solution combined Wavelet Transform with FFT and build a real system to monitor the onshore structures. Unlike other similar systems, our system is automatic through self-calibration and health fault detection, stream data mining of the sensor data acquired from the Motors, Generators .
1434
Abstract: Polyethylene is widely used as mulching plastic film in china cotton area. Collecting plastic film residue using machine is difficult. The cotton mixed with plastic film residue is badly harmful to cotton production, and causes great loss to cotton spinning enterprise. The detection system for cotton plastic covering using ultrasonic is developed in the paper. Sound wave echo method is used to detect plastic film residue mixed in seed cotton. The SCM is used to process echo signal and compensate measurement error caused by temperature variation. Experimental result shows that the system developed in the paper have features of low lost, high detection accuracy, high resolution and it has broad prospect in application.
1439
Abstract: This paper designs a multi parameter real-time water quality on-line monitoring system for aquaculture water. This system achieves the online monitoring among temperature, turbidity, DO (dissolved oxygen), pH and electrical conductivity. The crosstalk, produced by the simultaneous measurement with DO and pH sensors, will affect accuracy and stability of monitoring results. This paper analyzes the source of crosstalk, describes a circuit model of causing crosstalk, and designs an isolated circuit between powers and signals as well. The experimental results show that, the real-time monitoring of DO and pH has the characteristics of speediness, high precision, small error and low noise.
1445