Study on the Hydration Micro-Structure and Properties of Complex Cementitious Systems

Qing Jun Ding; Xiu Lin Huang; Hua Sun

doi:10.4028/www.scientific.net/AMR.150-151.783

Paper Titles

The Mechanical Properties of Modified Attapulgite Reinforced Nature Rubber and Styrene-Butadiene Rubber Nanocomposites
p.762

Experimental Study on Mechanicial Properties of TRC Plate
p.766

The Effect of IrO₂ Doping on the Structure and Magnetic and Magnetotransport Properties of La_0.7Ca_0.2Sr_0.1MnO₃ Composite
p.774

Research on Impact Behavior of Reactive Powder Concrete
p.779

Study on the Hydration Micro-Structure and Properties of Complex Cementitious Systems
p.783

Experimental Study on Salt Solution Ingress into Concrete under Capillary Siphon Effect
p.788

Preparation and Mechanical Properties of Nano-SiCp/Mg Composites by Ultrasonic Dispersion
p.792

Manufacturing and Mechanical Responses of Ti/APC-2 Nanocomposite Cross-Ply and Quasi-Isotropic Laminates at Elevated Temperature
p.796

Tribological Behaviors at High Load of MoS_X/Au Films in Vacuum
p.800

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 150-151Study on the Hydration Micro-Structure and...

Study on the Hydration Micro-Structure and Properties of Complex Cementitious Systems

Abstract:

In this study complex cementitious systems were prepared by cement, slag, fly ash and silica fume. Changing the dosages of mineral admixtures, then studying the strength and micro-structure of harden cement pastes by XRD,SEM,BET etc. Comparing the influence of variety and dosage of mineral admixture on cement pastes.Finally we found that mineral admixtures could improve the pore size distribution of cement pastes, and the total dosage 10% is better than 20%; and the "FA+SF" is better than others.