Dry Sliding Wear Behaviour of Fe-Based Powder Sintered Steel

Abstract:

Fe-based system powder metallurgy in the as-sintered was investigated on pin-on-rolling wear tester for their dry sliding wear behaviour. The morphology of worn surfaces and wear mechanism were analysed by SEM. Results show the hot-forging deformation quenching and tempered considerably decreased the porosity and improved wear resistance, and compare with quenching microstructure, tempered microstructure has high wear resistance and match of strength-toughness. Fe-2.0Ni-0.4Mo-0.5C-0.6Cr alloy presented best wear characteristics. SEM observations of the worn surface revealed microploughing and plastic deformation and crack were the basic dry sliding wear morphology,and oxidative wear and delamination wear are dominant wear mechanism.

• Periodical: Advanced Materials Research (Volumes 415-417)
• Pages: 707-710
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.415-417.707
• Online since: December 2011
• Authors: Hua Chen, Hai Ying Sun
• Keywords: Dry Friction and Wear, Hot-Forging Deformation, Iron Base Prealloying Powder

References

[1] D.Whittaker: Journal of the Japan Society of Powder and Powder Metallurgy.Vol.42 (1995), p.1093

[2] K.S. Narasimhan:Materials chemistry and physics.Vol. 67(2001),p.56

[3] H.Khorsand, S.M. Habibi,and H.Yoozbashizadea:Materials and Design.Vol.23(2002),p.667

[4] H.Chen, Y.Y.Li,and Y.B. Liu:Journal of Materials Processing Technology.Vol.182(2007),p.462

[5] W.unan,H.Danninger:Wear.Vol.222(1998),p.49

[6] S. Tekeli, A. Güral, and D. Özyürek:Materials & Design.Vol.28(2007 ),p.1685

[7] S. Dhanasekaran and R. Gnanamoorthy:Materials & Design.Vol.28(2007),p.1135

[8] S.C. Lim M.F. Ashby and J.H. Brunton:Acta Metallurgica.Vol. 35(1987),p.1343

[9] S.C. Lim, D.C. Isaacs, R.H. Mcclean, and J.H. Brunton:Wear.Vol.20(987),p.144

[10] G.Straffelini,A.Molinari: Wear.Vol.159(1992),p.127

[11] A. Molinari, G. Straffelini:Wear.Vol.173(1994),p.121

[12] K. V. Sudhakar ,P Sampathkumaran and E. S. Dwarakadasa:Wear.Vol. 242(2000),p.207

[13] K.Yamaguchi,N.Takakura and S.Imatani:Journal of Materials Processing Technology.Vol. 63(1997),p.364

[14] E.R. Leheup,Deen Zhang and J.R. Moon:Wear.Vol. 221(1998),p.86

[15] E.R. Leheup,Deen Zhang and J.R. Moon:Wear.Vol.176(1994),p.111

[16] L.Papoport:Wear.Vol.181(1995),p.280