A Contrast Experiment Based on the Modification Theory of Toroidal Worm

Abstract:

To discuss the modification rule of the toroidal worm and optimize its parameters, a contrast experiment is carried out on two toroidal worms which are modified under different modification rules in order to demonstrate the validity of curvature modification theory of toroidal worm. A pair of hindley worms is selected in the experiment. One is modified by the traditional symmetric rule; another is modified by the optimized symmetric rule based on the curvature modification theory. This article introduces the selection of worm’s parameters, the meas of modification and the manufacture of worm pairs. The experiment proves that the performance of the worm which is modified based on the curvature modification theory is much better than the worm modified by traditional symmetric rule. As the essential theory of the parameters optimization, the curvature modification theory is scientific and correct. It is the basis of the optimization and standardization of toroidal worm’s parameters.

• Periodical: Advanced Materials Research (Volumes 433-440)
• Pages: 4482-4489
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.433-440.4482
• Online since: January 2012
• Authors: Qing Ming Wen, Hua Xu, Wei Xiang Tang
• Keywords: Contrast Experiment, Modification, Toroidal Worm

References

[1] Yunfang Shen, Special engaging theory and worm wheel pair SG-71, , Metallurgical industry publisher, (1983).

[2] Yaxiong Zhang, Songchun, Hu Gear conduction design, Machine industry publisher, (1987).

[3] Liangyong Zhou, Innitial analysis about toroidal worm modification, The thesis album of the first China gear manufacture texchnology conference, 1991 p.327～332.

[4] Liangyong Zhou, Toroidal worm modification theory, China journal of mechanical engineering, 2002(2): p.112～115.

[5] Liangyong Zhou, Toroidal worm modification theory and manufacture technique, Publisher of National university of dfense technology, (2005).

[6] Qingming Wen, Zhou-liangyong, Conduction design of plane square enveloping toroidal worm, Contemporary machine, 2000(6): p.60～62.

[7] Xu Hua, Wen QingMing, Zhou LiangYong and Tang WeiXiang, The Study on the Optimization and Application of the modification parameters of toroidal worm-gearing, Proc. IEEE Symp. 2010 International Control & Industrial Engerneering (CCIE2010), IEEE Press, 5-6. 2010, pp.118-121.

DOI: 10.1109/ccie.2010.148

[8] The editorial board of hand book of gear", "Hand book of gear, Machine industry publisher, 1990 pp.6-94～94.