Research on Defining Regional Boundary of the COREX Melter Gasifier by Using Image Processing

Zhi Guo Luo; Li Hao Han; Xiao Lei; Zhan Xia Di; Jun Jie Sun

doi:10.4028/www.scientific.net/AMR.455-456.1140

Paper Titles

Optimization of Process Parameters of U-Shape Sheet Metal Based on Compensation of Geometric Springback Value
p.1122

Punching Teeth Layout on Steel Belt of the Box Based on Optimized Simulated Annealing Algorithm
p.1128

Adaptive Control of Synchromesh Shifting Process for Automated Manual Transmission
p.1132

Modeling Heat and Moisture Transfer within Porous Textiles under High Temperature Gradients
p.1136

Research on Defining Regional Boundary of the COREX Melter Gasifier by Using Image Processing
p.1140

Effect of Complex Agent on Copper Dissolution in Alkaline Slurry for Chemical Mechanical Planarization
p.1145

Effect of Colloidal Silica as Abrasive on Low-k Dielectric Materials in Chemical Mechanical Planarization
p.1149

Coupled Heat Transfer Simulations of Air-Cooled Turbines with an Algebraic Transition Model
p.1153

Optimal Design of High Power Linear Permanent Magnet Synchronous Motor for Aircraft Launch
p.1160

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 455-456Research on Defining Regional Boundary of the...

Research on Defining Regional Boundary of the COREX Melter Gasifier by Using Image Processing

Abstract:

In this paper, a two-dimensional hot model of melter gasifier, in which paraffin and corn are used to simulate DRI, coke and lump coal respectively, has been established to study the regional boundary in this paper. While the whole experimental process is recorded by the high-speed camera, the image processing method is put forward to define each regional boundary. By means of this method, the boundary of raceway, cohesive zone can be obtained quantificationally.