Bioadhesive from Distiller's Dried Grains with Solubles

C.Q. Fang; R. Auras; S.E. Selke

doi:10.4028/www.scientific.net/AMR.87-88.357

Paper Titles

Prediction of Process-Induced Residual Stress for Laminated Composites with Metallic Plate
p.333

Heat Transfer of Water Film Outside the Vertical Helix Tube with Hydrophilic Nanolayer
p.339

Preparation and Properties Study on the Composites of Polypropylene and Polyphenylene Sulfide Filled by Modified Molybdenum Disulfide
p.345

Study of Rheology of Flame-Retardant Copolyester Nanocomposites
p.351

Bioadhesive from Distiller's Dried Grains with Solubles
p.357

Preparation and Electrical Conductivity of Composites of PA66 Filled with Carbon Nanotubes
p.363

The Model Reconstruction of Carbon Black/Rubber Composites’ Heat Generation Ratio Based on Levenberg-Marquardt BP Algorithm
p.369

CAE Analysis of the Big-Size Injection Mold of Rear Bumper
p.375

Research on Microchannel of PMMA Microfluidic Chip under Various Injection Molding Parameters
p.381

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 87-88Bioadhesive from Distiller's Dried Grains with...

Bioadhesive from Distiller's Dried Grains with Solubles

Abstract:

Distiller's Dried Grains with Solubles (DDGS) is used to replace starch as a major feedstock material to produce bio-adhesive. The experimental conditions and the preparation process of the DDGS bioadhesive are outlined. The production and performance of DDGS adhesives were directly influenced by the heating temperature, heating time and concentration of hydroxide (NaOH) solution. When the heating temperature was 90 °C, the heating time was 10 min, and the concentration of NaOH solution was 30g/L, the yield of the DDGS adhesive was 61.6% wt/dry wt. The DDGS adhesive was less sensitivity to humidity than commercial starch adhesive.