Stress Intensity Factor Solutions for Narrow Plates

Abstract:

Accurate quantification of crack tip stress intensity values is paramount in the analysis of damage tolerant structures. The present analytical investigation seeks to determine the stress intensity solutions for crack geometries outside the existing valid solution space and expand the analysts ability to capture representative crack growth behavior. The focus of this investigation is to calculate the stress intensity factors of single quarter-elliptical corner cracks emanating from centrally located holes in finite width plates under various loading conditions (remote tension, bending, and pin loading). Many of the available finite width corrections are singled valued and universally applied to all locations along the crack front. Early investigations into the validity of this application indicated that this correction procedure produces stress intensity values +/- 30% from new solutions. The crack depth to length ratio and depth to thickness ratio can also significantly influence the accuracy of historical finite width solutions and corrections. The analytical investigation utilizes the three dimensional virtual crack closure technique and well-structured, completely hexahedral, element meshes. Stress intensity values are generated for a wide range of ratios for crack depth to crack length, crack depth to sheet thickness, hole radius to sheet thickness, and sheet width to hole diameter. This effort is being executed under a US DoD Technical Corrosion Collaboration program.

• Periodical: Advanced Materials Research (Volumes 891-892)
• Pages: 784-790
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.891-892.784
• Online since: March 2014
• Authors: Matthew J. Hammond*, Scott A. Fawaz
• Keywords: Finite Element Analysis (FEA), Finite Width Correction, Strain Energy Release Rate, Stress Intensity Factor (SIF), Virtual Crack Closure Technique

References

[1] AFGROW, LexTech, Inc., http: /www. afgrow. net.

[2] Cracks2000, University of Dayton Research Institute (UDRI), http: /cracks. udri. udayton. edu.

[3] NASGRO, Southwest Research Institute (SwRI), http: / www. nasgro. swri. org.

[4] J.C. Newman, Jr. and I.S. Raju, Stress-intensity factor equations for cracks in three-dimensional finite bodies subjected to tension and bending loads, Computation Methods in the Mechanics of Fracture, Elsevier Science Publishers B.V., 1986, pp.311-334.

DOI: 10.1520/stp37074s

[5] K.N. Shivakumar, P.W. Tan and J.C. Newman, Jr., A virtual crack-closure technique for calculating stress intensity factors for cracked three dimensional bodies, International Journal of Fracture 36 (1988).

DOI: 10.1007/bf00035103

[6] MATLAB, The MathWorks, Inc., http: /www. mathworks. com/products/matlab.

[7] TrueGrid, XYZ Scientific Applications, Inc., http: /truegrid. com.

[8] K.N. Shivakumar and J.C. Newman, Jr., ZIP3D - An elastic and elastic-plastic finite-element analysis program for cracked bodies, NASA Technical Memorandum 102753, November (1990).

[9] R.C. Shah, Stress intensity factors for through and part-through cracks originating at fastener holes, Mechanics of Crack Growth, ASTM STP-590, American Society for Testing and Materials, 1976, pp.429-459.

DOI: 10.1520/stp33961s

[10] S.A. Fawaz, B. Andersson, Accurate stress intensity factor solutions for corner cracks at a hole, Engineering Fracture Mechanics 71 (2004), pp.1235-1254.

DOI: 10.1016/s0013-7944(03)00207-8

[11] Personal correspondence with S.A. Fawaz, November (2011).