Observation of Microscopic Plastic Deformation of Polycrystalline Aluminum during Uniaxial Tension by Confocal Laser-Scanning Microscope

Abstract:

Article Preview

Info:

Periodical:

Key Engineering Materials (Volumes 274-276)

Edited by:

W.P. Shen and J.Q. Xu

Pages:

337-342

Citation:

H. L. Song et al., "Observation of Microscopic Plastic Deformation of Polycrystalline Aluminum during Uniaxial Tension by Confocal Laser-Scanning Microscope ", Key Engineering Materials, Vols. 274-276, pp. 337-342, 2004

Online since:

October 2004

Export:

Price:

$38.00

[1] I. Shimizu, T. Abe, T. Nosho and M. Wakayama, Metals and Materials, 4 (1998), pp.939-943.

[2] I. Shimizu, T. Nosho, T. Abe and H. Terai, AEPA'96 (1996), Eds. T. Abe and T. Tsuta, pp.277-282, Pergamon.

[3] B. Ralph, The Quantitative Description of the Microstructure of Materials, (1995), CRC Press.

[4] T. Abe, Y. Tai, I. Shimizu and T. Nosho, AEPA'96 (1996), Eds. T. Abe and T. Tsuta, pp.771-776.

[5] T. Abe, H. Song, Y. Akagi and I. Shimizu, Mem. Faculty Engg., Okayama Univ., 35 (2001), pp.1-8.

[6] H. Song, T. Abe, I. Shimizu, N. Tada, and T. Torii, to be published in J. Soc. Mat. Sci., 53 (2004).

[7] B. M. Schroeter and D. L. McDowell, Int. J. Plasticity, 19 (2003), pp.1355-1376.

[8] T. Bretheau, P. Massot and C. Rey, Trans. ASME, 106 (1984), pp.304-310.

[9] I. Hayashi and H. Sakata, Proc. 18th Jap. Cong. Mat. Res. (1975) pp.1-7.

[10] M. Sakamoto, and M. Nihei, J. Soc. Mat. Sci. 48 (1999), pp.44-48.

[11] G. Starzynski and W. Gambin, Acta Physica Polonica A 89 (1996), pp.377-381. 0. 1 0. 2 0. 3 0. 2 0. 4 0. 6 Line No.

[1] [2] [3] [4] [5] [7] [8] [9] Averaged value.

[6] Applied strain ε x Strain ε lx.

ε d x 0. 1 0. 2 0. 3 0. 2 0. 4 0. 6 Line No.

[1] [2] [3] [4] [5] [7] [8] [9] Averaged value.

[6] Applied strain ε x Strain ε lx.

ε d x (a) (b) (c) Fig. 15 Inhomogeneous deformation in grains measured with equal interval separated from the top to the bottom by 9 lines in the x-direction, (a) representation of measuring principle and position with grain No. 2, (b) for grain No. 3 and (c) for grain No. 4 shown in Fig. 13.