Effect of Varying Mixed Refrigerant Composition on Main Cryogenic Heat Exchanger Performance

Abstract:

LNG plant requires a lot of energy for its production especially in liquefaction process. One of the reasons is due to inefficiency on some of its major equipments, particularly on Main Cryogenic Heat Exchanger (MCHE). The efficiency of this unit can be improved by the usage of Mixed Refrigerant (MR) which matches closely the heating curve between hot and cold stream. However, the study on this refrigerant is complex and tedious due to multi component refrigerant and phase changing process inside MCHE. In this study, effect of varying MR composition towards MCHE performance is analyzed, with focus on heat transfer coefficient in shell side of MCHE. The analysis was based on single and two phase flow conditions which are gas flow and liquid falling film flow. The adjustment of binary components in MR composition was studied for each flow regime. By doing this, the best composition adjustment that gives the highest value of heat transfer coefficient was determined. It was found that the adjustment of methane-propane (C₁-C₃) is the best arrangement for both cases. However, it needs to be tested by applying this to actual process condition, in this case by implementing it in simulated LNG process.

• Periodical: Key Engineering Materials (Volumes 594-595)
• Pages: 13-17
• DOI: https://doi.org/10.4028/www.scientific.net/KEM.594-595.13
• Online since: December 2013
• Authors: Mohd Zaki Zainal Abidin, Usama Mohamed Nour, Ku Zilati Ku Shaari
• Keywords: Heat Transfer Coefficient, Main Cryogenic Heat Exchanger (MCHE), Mixed Refrigerant (MR)

References

[1] S.A. Al-Sobhi, H.E. Alfadala and M.M. El-Halwagi, (2009). Simulation and Energy Integration of a Liquefied Natural Gas (LNG) Plant, Proceeding of 1st Annual Gas Processing Symposium, 10-12 January 2009, pg 131-136.

DOI: 10.1016/b978-0-444-53292-3.50018-3

[2] M. Zargarzadeh, I.A. Karimi, H.E. Alfadala, (2007). Olexan: A tool for online exergy analysis. In proceedings of the ESCAPE 17, Bucharest, Romania, May 27-30.

[3] T. Shukri, (2004), LNG Technology Selection, Hydrocarbon Engineering February (2004).

[4] W. Ransbarger, (2007), A fresh look at LNG process efficiency, LNG Industry Spring (2007).

[5] M. Faruque Hasan, I. A. Karimi, H. Alfadala and H. Grootjans, (2007). Modeling and simulation of main cryogenic heat exchanger in a base-load liquefied natural gas plant. Computer Aided Chemical Engineering, Elsevier, pp.219-224.

DOI: 10.1016/s1570-7946(07)80060-5

[6] J.C. Pacio and C. A Dorao, (2010). A review on heat exchanger thermal hydraulic for cryogenic applications, Cryogenic, Vol 51, Issue 7, July 2011, pg 366-379.

DOI: 10.1016/j.cryogenics.2011.04.005

[7] S. Heldt, (2011). Near-Optimal Operation of LNG Liquefaction Processes by Means of Regulation, Ph. D thesis, Faculty of Process Science, Technical University of Berlin, Germany.

[8] R.F. Barron (1999). Cryogenic Heat Transfer, Taylor & Francis, Ann Arbor, Miami.

[9] J. C. Pacio (2012). Multiscale thermo-hydraulic modeling of cryogenic heat exchangers, Ph. D thesis, Faculty of Science and Engineering, Department of Energy and Process Engineering, Norwegian University of Science and Technology.

[10] B. O. Neeraas, A. O. Fredheim and B. Aunan, (2004). Experimental shell-side heat transfer and pressure drop in gas flow for spiral-wound LNG heat exchanger, Int. J. Heat Mass Transfer, vol. 47, pp.353-361, 1, (2004).

DOI: 10.1016/s0017-9310(03)00400-9

[11] B. O. Neeraas, A. O. Fredheim and B. Aunan, (2004). Experimental data and model for heat transfer, in liquid falling film flow on shell-side, for spiral-wound LNG heat exchanger, Int. J. Heat Mass Transfer, vol. 47, pp.3565-3572.

DOI: 10.1016/j.ijheatmasstransfer.2004.01.009

[12] V. Gnielinski (1998). Banks of Plain and Finned Tubes, Bergell House, Inc Section 2. 5. 3.

[13] G.S. Bays Jr and W. h, McAdams, (1937). Heat Transfer Coefficients in Falling Film Heaters, Massachusetts Institute of Technology.

[14] D.L. Bennet, B.L. Hertzler and C.E. Kalb, (1986). Down-flow shell-side forced convective boiling. AIChE Journal, Vol 32, Issue 12, pg 1963-(1970).

DOI: 10.1002/aic.690321205