Recycling of Exhausted Batteries and EAF Dusts by Leaching with Several Aqueous Media

Abstract:

Zinc is a base metal present in several products of general use, and therefore found in numerous residues and end-of-life products. The two main sources of zinc containing wastes are spent Zn-MnO₂ portable batteries and electric arc furnace (EAF) dusts from steelmaking plants. The recovery of metals from these residues by appropriate recycling processes is mandatory due to environmental, economic and resource conservation issues. Concerning the similar composition of both residues, their simultaneous processing can be envisaged. The research herein described consists on the hydrometallurgical treatment of zinc bearing waste, where several leaching routes for solubilising metals, mainly zinc, are studied. The leaching of shredded batteries and EAF dusts was carried out using three different leaching solutions containing sulfuric acid, hydrochloric acid or ammonium chloride. The acid leaching of zinc in the oxide form (zincite) using both acids, was very efficient and quick, allowing the recovery of practically all Zn contained in batteries and about of 80% of Zn in dusts. Regarding to the leaching media the behaviour of lead oxides present in dusts was different, being insoluble with H₂SO₄ and partially soluble with HCl (40-90% yield, depending on conditions). For battery waste stream, manganese is also other important metal, which oxides were only partially soluble in acid media, attaining a maximum leaching yield of 90% Mn. Iron, considered a contaminant in both residues, was partially leached and required further purification steps. The use of an ammoniacal medium (NH₄Cl) was very selective for zinc, being iron practically insoluble. However, the maximum zinc leaching yield attained for both residues was only near 60%. Under these conditions, manganese contained in batteries was very insoluble while lead from dusts was leached up to 70% due to the relative solubility of lead chloride. This research showed that hydrometallurgical treatment can provide versatile solutions for recycling metals from Zn waste. Ammoniacal leaching allows high selectivity for zinc but less recovery efficiency is attained, while acid leaching allows higher metal recovery yields but unwanted elements like iron are co-dissolved.

• Periodical: Materials Science Forum (Volumes 730-732)
• Pages: 636-641
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.730-732.636
• Online since: November 2012
• Authors: Fátima Pedrosa, Marta Cabral, Fernanda Margarido, Carlos A. Nogueira
• Keywords: EAF Dust, Leaching, Recycling, Spent Battery, Zinc Bearing Residue

References

[1] London Metal Exchange, LME Services: Non-ferrous metals, Zinc Industry usage, http://www.lme.com/zinc_industryusage.asp (accessed March 25, 2011)

[2] A.M. Bernardes, D.C.R. Espinosa and J.A.S. Tenório, Recycling of batteries: a review of current processes and technologies, J. Power Sources 130(1-2) (2004) 291-298

DOI: 10.1016/j.jpowsour.2003.12.026

[3] C.C.M. Souza and J.A.S. Tenório, Simultaneous recovery of zinc and manganese dioxide from household alkaline batteries through hydrometallurgical processing, J. Power Sources 136(1) (2004) 191-196

DOI: 10.1016/j.jpowsour.2004.05.019

[4] M.B.J. Freitas and M.K. Pietre, Electrochemical recycling of the zinc from spent Zn–MnO2 batteries, J. Power Sources 128(2) (2004) 343-349

DOI: 10.1016/j.jpowsour.2003.09.054

[5] R.N.G. Guerra, C.A. Nogueira and F. Margarido, Leaching studies of spent zinc-manganese alkaline batteries with sulphuric acid, Mater. Sci. Forum Vols. 587-588 (2008) 763-767

DOI: 10.4028/www.scientific.net/msf.587-588.763

[6] R.N.G. Guerra, F. Pedrosa, F. Margarido and C.A. Nogueira, Metals recovery from spent Zn-MnO2 batteries by Hydrometallurgy, In: B. Mishra, C. Ludwig and S. Das (Eds.), REWAS 2008 – Global Symp. on Recycling, Waste Treatment and Clean Technology (Proc.), Cancun, Mexico, 12-15 Oct., TMS, Warredale, USA, 2008, pp.1039-1044

[7] F. Tedjar, Recycling used electric cells by hydrometallurgical treatment, Patent Appl. WO2003/021708 A3. 13 March (2003)

[8] D. Martín, G. Díaz, M.A. García and F. Sánchez, Extending zinc production possibilities through solvent extraction, J. S. Afr. Inst. Min. Metall. Nov/Dec. (2002) 463-468

[9] I. Palencia, R. Romero, N. Iglesias and F. Carranza, Recycling EAF dust leaching residue to the furnace: a simulation study, JOM August (1999) 28-32

DOI: 10.1007/s11837-999-0238-9

[10] J.M. Figueiredo and F. Castro, O tratamento de poeiras de fornos a arco eléctrico siderúrgico e a reciclagem dos metais contidos – State-of-the-art, In: Materiais 93 – 6º Encontro da Sociedade Portuguesa de Materiais (Actas), Porto, Sociedade Portuguesa de Materiais, 27–29 Outubro, 1993, pp.325-332

DOI: 10.52590/m3.p632.a30001390