Realization of Al/Mg-Hybrid-Joints by Ultrasound Supported Friction Stir Welding

Abstract:

To realize modern light weight constructions it is more and more necessary to combine the advantages of dissimilar materials. Fusion welding of dissimilar metals is in the most cases difficult or even impossible as a result of different melting points of the materials and the development of undesirable brittle intermetallic phases in the welding zone. This often leads to joint strengths considerable below the tensile strength of the base materials. By using Friction Stir Welding (FSW) as a pressure welding method, it is possible to reduce the development of the intermetallic phases of Al/Mg-joints significantly. But as calculated phase diagrams and high resolution microscopic SEM-investigations have shown it is not feasible to avoid them completely. The intermetallic phases form in the contact area very small continuous layers between the joining partners. On the other side it is known that ultrasonic energy can crack oxide layers. Hence a hybrid welding system at the Institute of Materials Science and Engineering (WKK) at the University of Kaiserslautern was developed called “Ultrasound Supported Friction Stir Welding (US-FSW)” with the aim to shatter the brittle interlayer lines and to scatter fragments in the welding area during the FSW process. Pre-investigations have shown that for US-FSW-joints between Al wrought alloys and Mg cast alloys the strength can be increased up to 30% in comparison to conventional friction stir welds. Currently, further investigations are carried out with joints between AC-48000 and AZ80.

• Periodical: Materials Science Forum (Volumes 783-786)
• Pages: 1814-1819
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.783-786.1814
• Online since: May 2014
• Authors: Benjamin Strass*, Guntram Wagner, Dietmar Eifler
• Keywords: Aluminum (Al), Friction Stir Welding (FSW), Intermetallic Phase, Magnesium, Ultrasound Support

References

[1] O. Klag, J. Gröbner, G. Wagner, R. Schmid-Fetzer, D. Eifler, Microstructural and thermodynamic investigations on friction stir welded Mg/Al-joints, International Journal of Materials Research, accepted on Sep 12, (2013).

DOI: 10.3139/146.111003

[2] O. Klag, G. Wagner, D. Eifler: Mechanical Properties of Friction Stir Welded Mg/Mg- and Mg/Al-Joints. Advanced Engineering Materials 12, 2010, 1212.

DOI: 10.1002/adem.201000238

[3] K. U. Kainer, Magnesium Alloys and their Applications, Wiley-VCH, Weinheim, (2006).

[4] G. Mathers, The welding of aluminium and its alloys, Woodhead Publishing, Cambridge (2002).

[5] T. Jene, Entwicklung eines Verfahrens zur prozessintegrierten Prüfung von Rührreibschweißungen des Leichtbaus sowie Charakterisierung des Ermüdungsverhaltens der Fügungen, Werkstoffkundliche Berichte, TU Kaiserslautern, Kaiserslautern, 21, (2008).

[6] H. -D. Golde, Ultraschall-Metallschweißen, Verlag Moderne Industrie, Landsberg/Lech, (1995).