Effect of Charge Fractional Composition and the Coke Amount on the Parameters of Manganese Ore Agglomeration

Article Preview

Abstract:

Under laboratory conditions, the method of mathematical planning of experiments was used to study the effect of charge fractional composition (in the range of 2 to 8 mm) and the amount of coke in the charge (in the range of 7 to 13 wt.%) on the agglomeration process characteristics of the “Mamatwan” manganese ore (South Africa). It was found that the main agglomeration parameters vary within the following limits: the initial vacuum under grate – 54...140 mm WC for the charge layer of 350 mm; the maximum temperature – 1365...1440 °С; linear burning speed – 13,4...26,2 mm/min; the charge length of stay at temperatures over 1300 °С (the width of the melting zone) – 2,4...4,8 minutes. Mathematical equations of the combined effect of charge fractional composition and the amount of coke on agglomeration temperature, linear burning speed, width of melting zone (in time), initial vacuum in reactor were calculated. It was found that a major factor in providing the optimum mode of agglomeration is not the amount of coke, but the charge piece size distribution. For example, increasing the charge piece size has an 3,5 times more effective influence on the agglomeration temperature than the amount of coke. For the dust-containing charges the moistening up to 4...6 wt.% H2O is only partially solves the problem of the aerodynamic resistance. Pre-granulation of the dust fraction is needed to improve the gas permeability of the charge.

You might also be interested in these eBooks

Info:

Periodical:

Solid State Phenomena (Volume 265)

Pages:

945-951

Citation:

Online since:

September 2017

Export:

Price:

Permissions CCC:

Permissions PLS:

Сopyright:

© 2017 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

* - Corresponding Author

[1] E.F. Vegman, Theory and technology of agglomeration, Metallurgy, Moscow, (1974).

Google Scholar

[2] B. Wolfgang, Pietsch agglomeration process – phenomena, technologies, equipment, Wiley, Weinheim, (2002).

Google Scholar

[3] V.I. Korotych, Yu.A. Frolov, G.N. Bezdezhsky, Agglomeration of ore materials, Publishing house of the Ural State Technical University-UPI, Yekaterinburg, (2003).

Google Scholar

[4] S.N. Petrushov, Modern agglomeration process, Publishing house of Donbass State Technical University, Alchevsk, (2006).

Google Scholar

[5] V.I. Zhuchkov, L.A. Smirnov, V.P. Zaiko, U.I. Voronov, The technology of manganese ferroalloys, part 1, High-carbon ferromanganese, Ural Branch of the Russian Academy of Sciences, Yekaterinburg, (2007).

Google Scholar

[6] O.A. Artykbaev, A.K. Torgovets, Theory and technology of materials preparation for the metallurgical processes, part II, Karaganda State Industrial University, Temirtau, (2010).

Google Scholar

[7] D.A. Kovalev, N.D. Vanyukova, V.P. Ivashchenko, B.P. Krikunov, M.V. Yagolnik, M.N. Boyko, Theoretical foundations of agglomerated raw materials production, IMA-press, Dnepropetrovsk, (2011).

Google Scholar

[8] S.V. Krivenko, The intensification of agglomeration process based on the theory of development of layer gas dynamics, Publishing house of the Priazovsky State Technical University, Mariupol, (2016).

Google Scholar

[9] J. Daa Vittila, H. Krogerus, P. Oikarinen, R. Sarkkinen, Sintered manganese ore and its use in ferromanganese production, Proceedings of the ninth international ferroalloys congress (INFACON IX), The ferroalloys association, Washington DC, (2001).

Google Scholar

[10] K.P. Davey, The development of an agglomerate through the use of FeMn waste, Proceedings of the tenth international ferroalloy congress (INFACON X), Document transformation technologies, Irene, (2004) 272-280.

Google Scholar

[11] M.M. Tangstad, D. Leroy, E. Ringdalen, Behavior of agglomerates in ferromanganese production, Proceedings of the twelfth international ferroalloys congress (INFACON XII), Outotec oyj, Espoo, (2010) 457-465.

Google Scholar

[12] V. Singh, T.K. Ghosh, Y. Ramamurthy, V. Tathavadkar, Beneficiation and agglomeration process to utilize low-grade ferruginous manganese ore fines, Int. J. Miner. Process. 89 (2011) 84-86.

DOI: 10.1016/j.minpro.2011.03.003

Google Scholar

[13] I.V. Bezverkhy, A.A. Tomasz, Research of influence of intensifying factors on the agglomeration process indicators, Proceedings of Donetsk National Technical University. Metallurgy 11 (159) (2009) 3-12.

Google Scholar

[14] S.V. Krivenko, A.A. Tomasz, V.P. Russkih, The intensification of the agglomeration process by increasing the fuel combustion rate in the layer, Metal and casting of Ukraine. 7-8 (2009) 63-68.

Google Scholar

[15] E. Zh. Berdyshev, Zh.O. Nurmaganbetov, Development of sintering technology of fine- and coarsely dispersed manganese ores, Science and technology of Kazakhstan. 1-2 (2011) 17-20.

Google Scholar

[16] A.S. Tleuov, S.T. Tleuova, Zh.M. Altybayev, Manganese ore agglomeration using a carbonaceous waste, Modern science-based technologies. 8 (2014) 71-74.

Google Scholar

[17] V.A. Utkov, O.V. Zyryanova, V. Yu. Bazhin, Features of manganese agglomerate sintering, Ores enrichment. 4 (2015) 17-20.

Google Scholar

[18] A.A. Odintsov, Analysis of the status and prospects of development of the two-layer technology of agglomeration, Bulletin of the Siberian State Industrial University. 1(15) (2016) 3-8.

Google Scholar

[19] N.A. Spirin, V.V. Lavrov, Methods of planning and processing of engineering experiment results, Publishing house of the Ural State Technical University-UPI, Yekaterinburg, (2004).

Google Scholar

[20] V.V. Nalimov, N.A. Chernova, Statistical methods of the extreme experiments planning, Science, Moscow, (2010).

Google Scholar