Search results

The anaerobic filter adopts the type of upward flow, and the structure is shown in Fig. 2.
After drop aeration, effluent from the filter enters the horizontal subsurface flow constructed wetland, and the structure is shown in Fig. 3.
Jonsson: Water Science and Technology Vol. 48(2003), p. 61 [2] J H Ham, C G Yoon, J H Jeon and H C Kim: Water Science and Technology Vol. 55(2007), p. 503 [3] Sari Luostarinena, Wendy Sandersb, Katarzyna Kujawa-Roeleveldb and Grietje Zeeman: Bioresource Fechnology Vol. 98(2007), p. 980 [4] Yanlong Jin, Peng Zhou and Rui Wang: Environmental Science and Management Vol. 33(2008), p. 97 (In Chinese) [5] Chuanjun Ma, Qingzhi Fei, Zhi Xu, Fuquan Wang and Hongbo Hu: Environmental Chemistry Vol. 26(2007), p. 70 (In Chinese) [6] Fei Xiong, Wenchao Li, Jizheng Pan, Aiquan Li and Tianxiang Xia: Wetland Science Vol. 3(2005), p. 228 (In Chinese) [7] Lu Yan, Shihe Wang, Juan Huang, Yang Liu and Feng Wang: Environmental Science Vol. 29(2008), p. 627 (In Chinese)

(3)The cut tobacco was taken out while its storage time was over. 1kg cut tobacco was used to check moisture and structure of cut tobacco according to literature [4].
Then the structure of the broken cut tobacco was checked with YQ-2 cut tobacco vibration sieve sorting.
Chemistry of Plant Fiber.

In the past two decades, the use of microwave technique has attracted a considerable amount of attention, owing to its successful application in organic and inorganic synthesis of nanomaterials, material sciences, polymer chemistry, nanotechnology, and biochemical processes. 
The patterns are in good agreement with hexagonal structure with cell parameters a=b=0.7187nm and c= 0.735nm, α=β=90º, γ =120º known for bulk LaF3 (JCPDS card No.32-0483) [18].
This shows that the original structure of LaF3 may be retained even after the modification. [21].

Due to its adaptivity, EMD is widely applied to earthquake wave research [2], ocean engineering [3], chemistry and chemical engineering [4], structure analysis and damage detection [5], signal analysis and image processing [6]-[7].
Fuzzy inductive reasoning technique well tackle the similar or regular structure in the signal.

Study on Lipoprotein Lipase Production by Candida Rugosa Zhao Xing-xiu1，He Yi-guo2 1College of Bioengineering Sichuan University of Science & Engineering Zigong, China 2School of Chemistry and pharmaceutical Engineering Sichuan University of Science & Engineering Zigong, China 1zhaoxingxiu@sohu.com , 2heyiguo2000@sina.com Keywords:Candida rugosa; Lipoprotein lipase; Culture medium; Optimization Abstract.Candida rugosa can produce lipoprotein lipase by fermentation in the medium on a rotary shaker, the optimal medium compositions were determined as, the optimum pH was 6.0, the contant was 25ml, the inoculum age of strain was 24h, the inoculation was 10%,the rotation speed was 200r/min and the strain was cultured 27h at 28℃ .Under the optimum cultivation conditions, the maximum enzyme activity reached 121.65U/L.The result of enzyme properties showed, the optimum temperature and pH were 45℃ and 7.5 separately.
Introduction In recent years, along with the domestic unceasing raising of people's living standard and the promoting of people's diet structure gradually, the incidence of richness disease is obviously rising such as hypertension, hyperlipidemia, coronary artery disease, diabetes and fat disease [1], that has aroused the solicitude of whole society.
While the oretical research is also the necessary preparation of later work such as medification ,advanced structure, cloning and expression of lipoprotein lipase.

It has been reported [11] that AlN appears to be the most promising heterogeneous nucleation agent for Mg alloys, because AlN has a simple HCP structure with lattice parameters of a = 0.312 nm and c = 0.4988 nm [13], which are very close to the lattice parameters of the Mg matrix (HCP structure with a = 0.3209 nm and c = 0.5211 nm).
Further work is required to obtain uniformly distributed particles by modifying the melt chemistry, experimental set up and solidification conditions.

Y3+ or other cationic sites are more easily coordinated by F- with an increase of concentration of fluoride ion, which would decrease the energy barrier and result in the appearance of an ordered hexagonal structure.
By changing the molar ratio of fluoride to Ln3+, different sizes of NaYF4 NPs over the range of 40 nm to 1 µm can be obtained, and a transformation of crystal structure from the cubic phase to the hexagonal phase can perform in mild conditions.
Liu, “Recent advances in the chemistry of lanthanide-doped upconversion nanocrystals,” Chem.

The presence of functional epoxy group in the triglyceride and structure of vegetable oil allows them to react with any suitable reagent.
Hence it will take a place in the cross linking reaction with epoxy resin and gives it an opportunity to be incorporated into matrix structure than just act as a plasticizer.
Strong, (1998), Molecular design advances in resin chemistry, Compos Fabrication, 12, 18–24

Field-emission scanning electron microscopy, UV-vis transmittance spectra and Contact angle measurement were employed to characterize TiO2films.By the treatment of 500℃ for 2hrs, the nano-structured TiO2 film showed a water contact angle of below 10°andthe relative transmittance to quartz glass of over 90%.
The relationship between roughness and wettability was defined already by Wenzel who stated that adding surface roughness would enhance the wettability caused by the chemistry of the surface [9].
Multilayers comprising TiO2 nanoparticles with nanoporous structures should exhibit hydrophilicity.

The kinetics studies for the adsorption of furadan from aqueous solution by orange peel Xu Guangfu1, Shen Zhaoxi2, Guo Ruixin2* 1 Department of Analytical Chemistry, China Pharmaceutical University, Nanjing 210009, China 2 Department of Environmental Science, China Pharmaceutical University, Nanjing 210009, China *ruixinguocpu@163.com Keywords: Orange peel; Furadan; Adsorption; kinetics study Abstract.
The chemical structure of this pesticide was displayed in Figure 1.
Fig.1 The chemical structure of furadan used in this study Results and Discussion With the data in our preliminary work, Pseudo-first-order, second-order models and intraparticle diffusion model were applied to analyze experimental data and thus elucidated the kinetic adsorption process.