Search results

In addition, the prediction ability of this proposed constitutive model is verified by comparison with test data issued from the mechanical experiments [18-19].
This may be due to the reduction in the mobility of the macromolecular chains caused by the occurrence of both the fillers.

For rolling reductions larger than 50% the rolling textures essentially consist of the so-called b-fibre running from the copper orientation ("Cu") {112}<111> through the S orientation {123}<634> to the brass orientation ("Bs") {011}<211>.
Note that the required microchemistry data – including the particle density entering into the Zener-drag pZ (Eq. 6) as well as the concentration of solids css (Eqs. 2, 3, 7) – can be provided by suitable microchemistry models.

Duheisat revealed that cathodic hydrogen charging resulted in a reduction of the coefficient of sliding friction of copper [13].
The friction coefficient of the sliding couple was recorded continuously during the test by using a computer data-requisition system.

The diffraction data were recorded for 2y values between 101 and 801. 3.
Moreover, the images in Figure 3 revealed that the porosity of the observed CdS decreased with increasing the deposition cycle, the reduction on porosity implies that the volume of CdS particles has increased as a result of QDs deposition on the surface.

The duration will be determined from the experimental data.
Walsh: Riblets in Viscous Drag Reduction in Boundary Layers.

The second step defines the variable damage as a reduction in the active sections.
Remeshing essentially involves a new and better-conditioned mesh replacing the old mesh (distorted and fully damaged), and an accurate transfer of nodal and Gauss points data to the new mesh.

As shown in the picture, the X-ray diffraction (XRD) analysis of CdO matches the spectrum of the International Centre of Diffraction Data (JCPDS) reference card no. (05-0640).
The previous results indicate a consistent reduction in nanoparticle size as laser energy increases.

Introduction The onset of charge density wave order is marked by a spontaneous reduction of translational symmetry, as the electronic density is modulated along a wave vector which does not coincide with any of the reciprocal unit vectors belonging to the underlying atomic lattice [1].
Although the effects of fluctuations lead to the presence of a high-temperature tail which makes it difficult to quantitatively analyse the data, the general behavior of the two kinks is well captured by the predictions of the model in terms of combined charge and orbital order [9].

In chromogenic reaction the nitrite takes on amaranth, the quantity was obtained by spectrophotometric assay at 550nm.SOD in the testing can inhibit the superoxide specifically, resulting in the reduction of nitrite, thus absorbance of the testing will be lower than that of the control.
The formula as follows: Analysis of data All above experiments had been repeated three times.

All the specimens were tested with the same experimental setup designed according to the electro-hydraulic servo loading system of the civil engineering and disaster prevention and reduction key laboratory in Nanjing University of Technology.
Comparing between predicted results and experimental data prove that proposed model can predict the strength of strengthened masonry panels with good accuracy.