Papers by Author: Marek Skowronski

Abstract: For undoped 6H-SiC boules grown by physical vapor transport the variations of resistivity, of the type and density of deep electron and hole traps, and of the concentration of nitrogen and boron were studied as a function of position in the cross section normal to the growth axis and along the growth direction. It was observed that the concentrations of all deep electron and hole traps decreased when moving from seed to tail of the boule and from the center to the edge of the wafers. Modeling of the growth process suggests that the C/Si ratio increases in a similar fashion and could be responsible for observed changes. We also discuss the implications of such stoichiometry changes on compensation mechanisms rendering the crystals semi-insulating and on electrical uniformity of SI-SiC wafers.

Abstract: Growth rates and relative stability of 6H- and 4H-SiC have been studied as a function of growth conditions during Halide Chemical Vapor Deposition (HCVD) process using silicon tetrachloride, propane and hydrogen as reactants. The growth temperature ranged from 2000 to 2150 oC. Silicon carbide crystals were deposited at growth rates in the 100-300 μm/hr range in both silicon- and carbon-supply limited regimes by adjusting flows of all three reactants. High resolution x-ray diffraction measurements show that the growth on Si-face of 6H- and C-face of 4H-SiC substrates resulted in single crystal 6H- and 4H-SiC polytype, respectively. The growth rate results have been interpreted using thermodynamic equilibrium calculations.

Abstract: A novel approach to the high growth rate Chemical Vapor Deposition of SiC is described. The Halide Chemical Vapor Deposition (HCVD) method uses SiCl4, C3H8 (or CH4), and hydrogen as reactants. The use of halogenated Si source and of separate injection of Si and C precursors allows for preheating of source gases without causing premature chemical reactions. The stoichiometry of HCVD crystals can be controlled by changing the C/Si flow ratio and can be kept constant throughout growth, in contrast to the Physical Vapor Transport technique. HCVD was demonstrated to deposit high crystalline quality, very high purity 4H- and 6H-SiC crystals with growth rates comparable to other bulk SiC growth techniques. The densities of deep electron and hole traps are determined by growth temperature and C/Si ratio and can be as low as that found in standard silane-based CVD epitaxy. At high C/Si flow ratio, the resistivity of HCVD crystals exceeds 105
_cm. These characteristics make HCVD an attractive method to grow SiC for applications in high-frequency and/or high voltage devices.

Abstract: We present a survey of the most important factors relating to an epitaxial SiC growth process that is suitable for bipolar power devices. During the last several years, we have advanced our hot-wall SiC epitaxial growth technology to the point that we can support the transition of bipolar power devices from demonstrations to applications. Two major concerns in developing a suitable epitaxial technology are epilayer uniformity and extended defect density. Our state-of-theart capability permits the realization of 1-cm2 area devices with exceptional yields. Another major concern is the stability of bipolar devices during forward conduction. We have developed proprietary substrate and epilayer preparation technologies that have essentially eliminated Vf drift as a significant barrier to the exploitation of SiC based bipolar devices.