Papers by Author: Tatsuo Ozeki

Abstract: Low temperature deposition of HfO2 films on 4H-SiC(0001) substrates by pulse introduced metalorganic chemical vapor deposition (MOCVD) using tetrakis-diethylamido-hafnium [Hf[N(C2H5)2]4, (TDEAH)] and H2O has been investigated. HfO2 films with relatively low leakage current density of 10-4 A/cm2 were obtained even at a deposition temperature as low as 190 °C. We demonstrate that the HfO2/SiC interface, where the HfO2 was deposited at 190 °C, has lower interface state density than a typical thermally-grown SiO2/SiC interface. It is also shown by X-ray photoelectron spectroscopy (XPS) that the HfO2/SiC structure fabricated at 190 °C has lower SiOx count than the HfO2/SiC structure fabricated at 400 °C.

Abstract: Prototype SiC power modules are fabricated using our class 10 A, 1.2 kV SiC-MOSFETs and SiC-SBDs, and their switching characteristics are evaluated using a double pulse method. Switching waveforms show that both overshoot and tail current, which induce power losses, are suppressed markedly compared with conventional Si-IGBT modules with similar ratings. The total switching loss (MOSFET turn-ON loss, turn-OFF loss and SBD recovery loss) of SiC power modules is measured to be about 30% of that of Si-IGBT modules under the generally-used switching condition (di/dt ~250A/μs). The three losses of SiC modules decrease monotonically with a decrease in gate resistance, namely switching speed. The result shows the potential of unipolar device SiC power modules.

Abstract: 4H-SiC epilayer channel MOSFETs are fabricated. The MOSFETs have an n- epilayer channel which improves the surface where the MOS channel is formed. By the optimization of the epilayer channel and the MOSFET cell structure, an ON-resistance of 12.9 m
cm2 is obtained at VG = 12 V (Eox = 2.9 MV/cm). A normally-OFF operation and stable avalanche breakdown is obtained at the drain voltage larger than 1.2 kV. Both the ON-resistance and the breakdown voltage increase slightly with an increase in temperature. This behavior is favorable for high power operation. By the evaluation of the control MOSFETs with n+ implanted channel, the resistivity of the MOS channel is estimated. The MOS channel resistivity is proportional to the channel length and it corresponds to an effective channel mobility of about 20 cm2/Vs.