Injection Molding Process Parameters Analysis and Optimization Depending on Moldflow

Abstract:

t was carried out the simulation experiment for injection molding process by the factorial experiment method and the Moldflow software. The model was a computer panel. The responses target to experiment was the warpage. The data was used the ANOVA analysis which came from the factorial experiment. The effect levels of the parameters were got, such as the mold temperature, the injection time, the pressure, the melt temperature et .al. Through the analysis of the response figures, it obtained injection molding process parameters of the optimal combination plan, and the simulated verification process. The experiment proved that this method can reduce test times and guarantee the excellent quality of products.

• Periodical: Applied Mechanics and Materials (Volumes 401-403)
• Pages: 848-851
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.401-403.848
• Online since: September 2013
• Authors: Na Li, Hong Bin Liu
• Keywords: Factorial Experiment, Molding Injection, Process Parameter, Warpage

References

[1] Qingguo Ding, Hongbin Liu: Plastics Industry, 2012. 7.

[2] Changyu Shen, Jingbo Chen, Chuntai Liu: Mould industry, 1998 (3).

[3] Plastic mold technical manuals, edited by Plastic mold technical manual editorial board. Beijing, 1997, in press.

[4] Statistics for Experiments：an Introduction to Design，Data Analysis and Model Building, New York, edited by Box G.P. ，Hunter J．S John Wiley&Sons, 1978, in press.