Error Autocompensation of Micromachined Gyroscopes

Zi Ming Qin; Wei Zheng Yuan; Hong Long Chang; Jian Bing Xie

doi:10.4028/www.scientific.net/AMR.60-61.274

Paper Titles

Inducing Layer Dependence of BiFeO₃ Based Multilayer Capacitors
p.256

The Effect of Different Flow Patterns on Anode Fluid Behaviors of Micro Direct Methanol Fuel Cells
p.260

The Design of a MEMS Surface Resonant Magnetometer
p.265

Effect of the Prepared Proceeding on Mechanical and Tribological Properties of DLC Films
p.270

Error Autocompensation of Micromachined Gyroscopes
p.274

Substrate Dependent Morphologies and Luminescence Properties of ZnO Nanostructures Prepared by Thermal Evaporation
p.278

Preparation and Optical Absorption Properties of CuO/SiO₂ Nanocomposite Films Fabricated by Sol-Gel Technique
p.283

Investigation of Thermal Bonding on PMMA Capillary Electrophoresis Chip
p.288

Deep Hole Fabrication Based on ICP Process
p.293

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 60-61Error Autocompensation of Micromachined Gyroscopes

Error Autocompensation of Micromachined Gyroscopes

Abstract:

. Error autocompensation using a non-MEMS micromotor is used to reduce the drift of micromachned gyroscopes. Theoretic deviation, numerical simulation and experiments are carried out. Test results show that the bias instability of micromachined gyroscopes is reduced from 542°/h to 39°/h, which makes their high end applications possible