Effect of Si Content on Property of Al-Si-Mg Strip Cast Using High Speed Twin Roll Caster

Toshio Haga; Hiizu Ochi; Hiroshi Fuse; Hisaki Watari; Shinichi Nishida

doi:10.4028/p-AI0uu9

Paper Titles

Influence of Carbon Content on the Strengthening Characteristics of Steels during AFSH
p.11

Study of the Kinetics of Plastic Deformation Propagation in a Welded Joint of 10G2FB Steel after Submerged Arc Welding
p.19

Microstructural Effects on the Fragmentation of High-Carbon Steel Cylindrical Shells under Explosive Loading
p.31

Steel Microstructure Prediction Mechanism Using Convolutional Neural Networks
p.39

Effect of Si Content on Property of Al-Si-Mg Strip Cast Using High Speed Twin Roll Caster
p.47

Microstructural and Mechanical Properties of Flash SPS WC-Co/AISI 304L Diffusion Bonded
p.53

Effect of Impurity on Casting of Al-25%Si Heat Sink with Thin Fins
p.59

Effect of Mold Lubricant on Flow Length of Al-Mg Alloy in Die Casting
p.65

Study on Cutting Edge Shape in Surface Processing with Indexable Non-Rotational Cutting Tool Using Damping Alloy
p.71

HomeMaterials Science ForumMaterials Science Forum Vol. 1163Effect of Si Content on Property of Al-Si-Mg Strip...

Effect of Si Content on Property of Al-Si-Mg Strip Cast Using High Speed Twin Roll Caster

Abstract:

Al-Si-Mg alloy strips with a Si content ranging from 0.5% to 12% were cast using a vertical type high-speed twin-roll caster at a roll speed of 60 m/min. The effect of Si content on ripple marks and cracks on the cast surface, as well as center cracks (crocodile cracks), was investigated. The results show a relationship between the Si content and these defects. When the Si content was higher than 4%, surface cracks and center cracks did not occur. However, ripple marks worsened when the Si content ranged from 3% to 5%.