Search results

Effect of initial lead concentration on adsorption Initial concentration (mg/l) 5 10 15 25 50 Lead removal efficiency (%) 29.92 32.50 36.40 51.28 56.22 The results obtained indicated that with the increase of the initial concentration of lead, the percentage reduction of this metal ion improved.
· The experimental data of the adsorption equilibrium are in perfect agreement with the Freundlich and Langmuir model with a maximum adsorption capacity of the order of 16.613 mg / g.

Advanced CAD systems, particularly Building Information Modeling (BIM), enhance collaboration between stakeholders by providing real-time data integration and visual representation of structural components [4].
As a result, engineers can make informed decisions that align with global sustainability goals, including the reduction of greenhouse gas emissions [6].

Materials data are given in Table 2.
Finally, the power cycling tests revealed that the baseplate solder layer has smaller infuence than chip solder layer, bonding wires stress reduction is one of the causes for module failure due to power on and power off when solders exist voids.

The data of the microstructural and X-ray diffraction analysis were completely consistent and indicated the content of zirconium dioxide in the electrocorundum in amount 35–40 wt. % [18].
In our case, the control of the degree of reduction of zirconium electrocorundum samples was carried out by introducing the following reducing agents into the charge: 0,5 wt % carbon and 1–2 wt % metals (Al, Ti).

External Volume Index (EI) [11] EI= Volume out of PTV, no less than the prescribed dose /PTV ②Normal Tissues and Organs Liver: D1/3 (dose on 1/3 liver); Dmean (the mean dose on livers) Spinal Cord: Dmax (the maximum injectivity on spinal cord) Kidney: D1/3 (dose on 1/3 liver); D1/2 (dose on 1/2 kidney) 1.3 Statistical methods: the SPSS 13.0 software was used for data analysis, and the difference between sample means was tested by one-way ANOVA, and LSD method was used for the pairwise comparison of indicators.
[10] Murshed H,Liu HL,Liao Z,et al.Dose and volume reduction for nomal lung using intensitymodulated radiot herapy for advanced stage non-small-cell lung cancer[J].Int J Radiat Oncol Biol Phys,2004,58:1258-1267

In the same manner, an optimization of the process selectivities based on the data reported in Figure 3 was also executed (Figure 5).
Furthermore the PE-ALE approach also showed much greater control in the reduction of particle contamination following a soft-masked etch of TiN mask material.

In Fig. 9 it can easily be seen that the increase of temperature caused a reduction of the crack width at the inlet nearly back again to an average of 0.1 mm and the corresponding leakage (grey line in Fig. 9) decreased from a value of 24 kg/h to less than 20 kg/h.
Further evaluation of the test data and the crack pattern is still ongoing and numerical simulations of all tests of the campaign are underway.

The use of raw material in construction is gaining more interest due to their relatively low embodied energy and reduction of carbon footprint in construction industry.
The DIC data processing was performed with 7D software developed by the laboratory SYMME (Vacher et al.,1999).

Fig. 5 Transmission spectra of a glass substrate and TiO2 films at different annealing temperatures: (a) 100 °C, (b) 200 °C and (c) 300 °C Fig. 6 FTIR spectra of the TiO2 films at different annealing temperatures: (a) 100 °C, (b) 200 °C and (c) 300 °C The Tauc plot data (not shown here) also shows an exponential tail near the optical band edge called Urbach tail and related to Urbach energy EU.
The alteration of both energies resulted from oxygen-vacancy reduction [12].

As to preparing UHSCM, there are four theoretical principles, including reduction in porosity, improvement in microstructure, enhancement in homogeneity and increase in toughness [8].
And t is the width of the test block, t= 40mm.Suppose the P is in KN units, δ is in mm and E is in GPa units, put the relevant data into Eqs. 3 and 4, elastic modulus can be obtained