Search results

Hot rolling was conducted for attaining sheet with high reduction rate 2mm thickness.
The lattice parameters obtained from the XRD data are 3.722 Å and 3.679 Å for the kappa carbides and γ-matrix, respectively [21].

Presented data are for untreated a-Si:H film and different sample geometry: 1-1, 1-2, 2-1 and 2-2.
The photoconductivity of the samples after irradiation decreased by 4 times and more due to amorphous silicon phase volume fraction reduction caused by material ablation and crystallization.

On the contrary, the ethylene links (-CH2-) or ether (-O -) will bring, as hinge, mobility and flexibility to the network and also a reduction of viscosity.
Fig. 10: Complex shear modulus of the filled adhesive: comparison between experimental data and Palierne model.

Rubber foam specimens for properties testing after vulcanization were prepared using a compression moulding process at 170 °C, with different curing times for each rubber formulation based on data from cure characterization.
With the previously mentioned increase in average pore size, the compressive strength decreased from 0.112 to 0.071 MPa, a reduction of approximately 57%.

What’s more, the overexploitation of firewood causes the huge damage to the vegetation, which induces water and soil loss, soil organic matter reduction and some other bad effects.
But the data showed that most rural new residential were self-established buildings[3].

Introduction Aluminum alloys have been widely used as key structural materials in automobiles [1, 2], ships [3, 4], bullet trains [5] and aircraft [6-8] to meet the comprehensive requirements of desired mechanical properties, weight reductions and fuel consumption improvements.
Three measurements were executed for each group so as to guarantee the reliability of the experiment data.

Despite the reduction in mechanical strength, the stabilized kaolinitic clay exhibits potential for use in unfired forms for earth construction due to its enhanced durability.
Okeiyi, “Use of quick and hydrated lime in stabilization of lateritic soil: comparative analysis of laboratory data,” International Journal of Geo-Engineering, 8(3), (2017), 1-13, doi: 10.1186/s40703-017-0041-3

The XRD data and curves reveal that the RE doped barium ferrites (D-BaM) have been successfully prepared.
Zhang, et al, Influence of (RGO)/(ferrite) ratios and graphene reduction degree on microwave absorption properties of graphene composite, J.

In addition, this reduction in stresses at 24 degrees is slightly less than the von Mises stress in the fixture, making the fixture more likely to get plastic.
Torsten, "Data on implant failures will show different results depending on how patients are compiled and analyzed: A retrospective study on 3902 individual patients treated either with one single implant or implants in the edentulous upper jaw", Clinical Implant Dentistry and Related Research 22.2 (2020), pp. 226-236

They found that corrosion and wear resistance of the new samples was improved compared with the base metal, and conclude that attribute to the reduction of grain size and the mismatch of thermal expansion coefficient between base metal and reinforced particles, while the lubrication effect of Fe78Si9B13 particles plays the role of improving wear resistance.
Using an orthogonal array and investigating the S/N ratio obtained from samples information, the data were analyzed using MINITAB16 software.