Search results

One of those adopted in Focacci et al (2017) to reproduce the bond behavior of a PBO FRCM composite are provided in Figure 1c for reference.
El Refai, U.

Al-Sumaidae, “Temperature and stress evaluation during three different phases of friction stir welding of AA 7075-T651 alloy,” Modelling and simulation in engineering, 2020, pp.1-11, 2020
El-Sayed, A.

Graphene Oxide was synthesized according to the modified Hummer’s method as described by Paulchamy et al. (2015) [15].
The linear form of the Freundlich equation can be expressed in the following equation as described by Boparai et al. (2011) [18]:
Moreover, a study by White et al. (2018) stated that precipitation of copper as Cu(OH)2 is more likely to be dominant than Cu(II) ions as pH>7.
Yang, Micro characterization and degradation mechanism of liquid silicone rubber used for external insulation, IEEE T Dielect El In. 22 (2015) 313-321

Wouterson et al. [3] reported a different trend in the values of Etρ which is subject to the type of microsphere used, a linear increase in Etρ was observed for K46 type of microsphere, whereas K15 microspheres show a constant trend with no noticeable increase in the value of Etρ but the phenolic microspheres decrease in Etρ as the volume fraction of HGM increases.
Wouterson et al. [3], also reported a similar case whereby the σf/ ρ was maximum at the concentration with the highest HGM volume fraction.
Ding, et al., Compressive properties of co-continuous hollow glass microsphere/epoxy resin syntactic foams prepared using resin transfer molding.
El-Hadek, H.

Britchi, Mircea Olteanu, Niculae Ene and Petru Nita, Diffusion layers with Ti and Ti+Al formed on 316L austenitic steel by a pack cementation procedure, Defect Diffus.
Sader, E.L.

Xiao Linlin et al[10] studied the rate of cholesterol reduction of strain KM-16 is up to 51.8%, which are strong strains of cholesterol-lowering capabilities.
[11] Psomas EI, Fletouris DJ, Tzanetaki EL,“Assimilation of cholesterol by yeast strains isolate form infant feces and feta cheese,”J Dairy Sci, vol. 86, 2003, pp.3416-3422

Kaynak et al., BiCMOS embedded RF-MEMS switch for above 90 GHz applications using backside integration technique, IEEE International Electron Devices Meeting (IEDM) (2010) 36.5.1-36.5.4
El-Gamal, A MEMS-based temperature-compensated vacuum sensor for low-power monolithic integration, IEEE International Symposium on Circuits and Systems (ISCAS) (2010) 3276-3279

This amorphous nature agrees with the assumption made in the model of film growth proposed by Chandar Shekar et.al [30].
[10] A.EL-Khodary, Vibrational, thermal, optical and magnetic investigations of PVA films filled with FeCl3 and CoCl2 Physica B:Condensed Matter. 404 (2009) 1287-1294

The technique is as follows (Borri et al. 2013): before wrapping the cords, mortar joints were first carefully raked out to a depth of 15 mm (being careful to remove only the damaged mortar) and then their corners were rounded up to 20 mm to avoid stress concentration (Fig. 1a).
El Gawady, P.

A. and El-Baradie, M.
Moreover Palanisamy et al. detected that the application of coolant under a pressure of 90 bar in turning titanium alloys results in increased frequency of chip serration, shear-band thickness and average chip thickness compared to a pressure of 6 bar [[] Palanisamy, S., McDonald, S.D., Dargusch, M.S., 2009, Effects of coolant pressure on chip formation while turning Ti6Al4V alloy, International Journal of Machine Tools and Manufacture, 49:739-743. ].