Search results

The samples investigation by X-Ray diffraction was carried out using Bruker D8 Advance diffractometer.
Dahmen: Journal of Metallurgy (Association of Metallurgical Engineers of Serbia) Vol.12 (2006), p. 309 [2] A.B.
Prangnell: Materials Science Forum Vol.396-402 (2002), p. 39 [4] J.

A study on dry sliding wear behaviour of hybrid metal matrix composites at room temperature N.G.Siddesh kumar1, a, G.S.Shiva Shankar1, a*, S.Basavarajappa2, b. 1* Department of Mechanical Engineering, Siddaganga Institute of Technology, Tumkur- 572103, Karnataka, India. 2Department of Studies in Mechanical Engineering, University BDT College of Engineering, Davangere-577004, Karnataka, India.
Introduction Aluminium metal matrix composites suggest broad range of properties for huge number of engineering applications.
Brampton ,The Reactive Wetting and Incorporation of B4C particles into Molten Aluminium,Advanced Materials Research Group, University of Nottingham, Nottingham NG7 2RD, U.K.
Kerti, The Effect of Ti Addition on the Properties of Al-B4C Interface:A Microstructural Study,Materials Science Forum Vols. 636-637 (2010) pp 192-197 (2010), Trans Tech Publications
[26]Siddesh Kumar N G, Ravindranath V M, G S Shiva Shankar, Dry Sliding Wear Behaviour of Hybrid Metal Matrix Composites, International Journal of Research in Engineering and Technology, Vol.3,Special Issue 3 ,May-2014,p-ISSN:2321-7308 E-1SSN:2319-1163,ISBN:078-1-63041-810-6

This give a highlights that engineering WTS filters to resist bacterial adhesion, such as through the application of antifouling coatings, or surface texturing that target the specific characteristics of the bacterial strains present could prevent the initial attachment of biofilm-forming bacteria.
British Journal of Multidisciplinary and Advanced Studies, 2023. 4(3): p. 1-78
Journal of Genetic Engineering and Biotechnology, 2023. 21(1): p. 115
[34] Rodriguez-R, L.M., et al., An ANI gap within bacterial species that advances the definitions of intra-species units.
[65] Brooke, J.S., Advances in the microbiology of Stenotrophomonas maltophilia.

To make the wing design efficient and manufacturable it should have an air foil cross-section and the wing must not stall while flapping: the advanced ratio i.e. ratio of airspeed to tip speed for an ornithopter should be less than 1, it's important that wing tip feathers at around 8 to 15 degrees to avoid a stall.
Jangid (2014) " Ornithopter Design And Operation " International Journal of Mechanical and Production Engineering (IJMPE) pp. 64-67, Volume-2,Issue-4
Journal of Bionic Engineering 9 (2012) 391–401
Journal of Wind Engineering and Industrial Aerodynamics, 83(1-3), pp.109-120
International Research Journal of Engineering and Technology (IRJET), Volume: 07 Issue: 08 | Aug 2020

Rahim1,3,d 1UM Power Energy Dedicated Advanced Center (UMPEDAC), Level 4, University of Malaya, Jalan Pantai Baharu, 59990 Kuala Lumpur, Malaysia 2Heat Transfer Laboratory, Kyushu Institute of Technology, Tobata campus,1-1 Sensuicho, Tobata Ward, Kitakyushu, Fukuoka 804-8550 JAPAN 3Renewable Energy Research Group, King Abdulaziz University, Jeddah 21589, Saudi Arabia amirul90@um.edu.mya, farahkhaleda@yahoo.comb, venga@um.edu.myc, nasrudin@um.edu.myd Keywords: Solar cell, nanoparticles coatings, temperature, fill factor Abstract.
Hurley, "A thermal model for photovoltaic panels under varying atmospheric conditions," Applied thermal engineering, vol. 30, no. 11-12, pp. 1488-1495, 2010
Nawade et al., "Copper based transparent solar heat rejecting film on glass through in-situ nanocrystal engineering of sputtered TiO2," Ceramics International, vol. 48, no. 2, pp. 2482-2491, 2022
Han, "Super-hydrophobicity of silica nanoparticles modified with vinyl groups," Colloids and Surfaces A: Physicochemical and Engineering Aspects, vol. 338, no. 1-3, pp. 15-19, 2009
Kaenphakdee et al., "Synthesis Study of Silver-Doped Zinc Oxide for Near-Infrared Shielding Applications," in Materials Science Forum, 2020, vol. 1007: Trans Tech Publ, pp. 143-147

Engineering of nature management. 3(13) (2019). 102–109
Engineering Geology. 97. 3–4 (2008). 97–111
International Journal of Geosynthetics and Ground Engineering. 1(3) (2015). 24 s
European Journal of Environmental and Civil Engineering. 2018
Advanced Materials Research. 599 (2012). 640–646

It can have stimulation to different evaluation units to establish scientific and reasonable evaluation method of management effectiveness, thus it is propitious to find the gaps, analyse the subjective reasons of inefficient economic behavior, and mobilize the enthusiasm of people to improve economic efficiency and technological advances.
Journal of the Chinese Institute of Industrial Engineers. 2005,22(3):243~251 [10] WEI Quanling.
Forum Vol. 83-87 (1992), p. 119

., National Association of Corrosion Engineers, Houston, TX, 1969), p. 466
Hyatt, Advances in Corrosion Science and Technology (Vol. 2 M.
Forum, Vol. 294-296 (1999), p. 477

Electrical Your Paper's Title Starts Here: Please Center use Helvetica (Arial) 14Characteristics of ZnTe Thermoelectric Thin Films Wen-Shiush Chen1,a, Cheng-Hsing Hsu1,b, Wen-Hua Kao1, First Author1, a, Second Author2,b and Others3,c Yi-Ting Yu1, Pai-Chuan Yang1, Ching-Fang Tseng2, Chun-Hung Lai2, Ye-Mu Lee2, Hsi-Wen Yang3 and Jenn-Sen Lin4 1Full address of first auDepartment of Electrical Engineering and Computer Science, National United University, No. 1, Lien-Da, Kung-Ching Li, Miao-Li 36003, Taiwanthor, including country 2Full address of second author, including countryDepartment of Electronic Engineering, National United University, No. 1, Lien-Da, Kung-Ching Li, Miao-Li 36003, Taiwan 3Department of Materials Science and Engineering, National United University, No. 1, Lien-Da, Kung-Ching Li, Miao-Li 36003, Taiwan 4Department of Mechanical Engineering and Computer Science, National United University, No. 1, Lien-Da, Kung-Ching Li, Miao-Li 36003, Taiwan a3List all distinct
Forum Vol. 83-87 (1992), p. 119 [2] M.A.
Mishing, in: Diffusion Processes in Advanced Technological Materials, edtied by D.
London, United Kingdom: INSPEC, The Institution of Electrical Engineers, United Kingdom (1997)

Makinde3,c 1, 2Department of Mathematics, School of Advanced Sciences, VIT University, Vellore- 632 014, India 3Faculty of Military Science, Stellenbosch University, Private Bag X2,Saldanha7395,SouthAfrica E-mail: alathajayakar@gmail.com, b*rushikumar@vit.ac.in, cdmakinde@yahoo.com Keywords: peristaltic flow, Jeffery fluid, Newtonian fluid, heat dissipation, permeability, magnetic field parameter.
Azam Effect of heat sink / source on peristaltic flow of Jeffery fluid through a symmetric channel, Alexandia Engineering Journal, 54 (2015) 733-743 [16] G.B.Jeffery, The Motion of Ellipsoidal Particles Immersed in a viscous fluid, Mathematical, physical and Engineering sciences, 102 (1922) 161-179 [17] M. kothandapani, S.
Makinde, Hydromagnetic peristaltic motion of a reacting and radiating couple stress fluid in an inclined asymmetric channel filled with a porous medium, Alexandria Engineering Journal, 55 (2016) 1841-1853 [37] M.
Tshehla, Magneto hemodynamics of nanofluid with heat and mass transfer in a slowly varying symmetrical channel, International Journal of Engineering Research in Africa,  28 (2017) 118-141 [40] K.F.
Makinde, Magneto-hemodynamics mixed convection with radiative heat transfer in a stenosed artery, Defect and Diffusion Forum, 378 (2017) 68-84