Advanced Materials Research
Vols. 450-451
Vols. 450-451
Advanced Materials Research
Vols. 446-449
Vols. 446-449
Advanced Materials Research
Vol. 445
Vol. 445
Advanced Materials Research
Vols. 443-444
Vols. 443-444
Advanced Materials Research
Vol. 442
Vol. 442
Advanced Materials Research
Vol. 441
Vol. 441
Advanced Materials Research
Vols. 433-440
Vols. 433-440
Advanced Materials Research
Vols. 430-432
Vols. 430-432
Advanced Materials Research
Vol. 429
Vol. 429
Advanced Materials Research
Vol. 428
Vol. 428
Advanced Materials Research
Vol. 427
Vol. 427
Advanced Materials Research
Vol. 426
Vol. 426
Advanced Materials Research
Vols. 424-425
Vols. 424-425
Advanced Materials Research Vols. 433-440
Paper Title Page
Abstract: A fully integrated 5.2GHz variable gain low noise amplifier (VGLNA) in a 0.18μm CMOS process is proposed in this paper. The VGLAN can achieve a maximum small signal gain of 17.85 dB within the noise figure (NF) of 2.04 dB and a minimum gain of 2.04 dB with good input return loss. The LNA’s P1dB in the high gain mode is -17.5 dBm. The LAN consumes only 14.58 mW from a 1.8V power supply.
5579
Abstract: This article is designed based on Samsung's S3C2410 company as the main processor, Cruise system, using CAN bus process communication and exchange, using Real Time Embedded Systems operating system, greatly improving the system running the real-time nature and stability. Microprocessor on the sensor signals collected were processed, as confirmed when the need to open the main cruise control switch, and then to cruise speed up or slow down. Upon completion of desired goals, the disconnect cruise switch, out of cruise, the system also has fault diagnosis, and with diagnostic interface to prepare for maintenance use.
5584
Abstract: a new queue system based on Global System for Mobile Communications(GSM) modem and single chip microcomputer’s communication is proposed. This system can be connected to personal computer (PC), which will have interference superior to single chip microcomputer (SCM). The customers will be informed by SMS when their turn is around the corner. The viability and stability of this system is discussed hereinafter via debugging and testing.
5591
Abstract: A texture synthesis algorithm based on SFLA-PSO and block increasing is presented for example-based synthesis. It can be used to speed up texture synthesizing through using the texture block of which size is increased by times of two during the process of texture synthesis; As the searching tactics of texture block matching, SFLA and PSO are combined to accelerate and improve the global searching performance. The experimental results prove that the algorithm can evidently accelerate texture synthesis on the premise of fine synthesis quality, and overcome the defect of easily falling into local optimal solution of PSO algorithm.
5596
Abstract: This paper presents a method of automated testing inflexion of OCXO by computer. It has been greatly reduced the debugging process and production time of OCXO through the configuration consisted by computer software and AVR single chip designing. All the advantages mentioned above contribute to the mass production of OCXO
5601
Abstract: An embedded application system must have Bootloader. It is introduced in this paper that the bootloader design for an embedded minimum system based on S3C44B0X that is a processor with ARM7TDMI kernel. The design of the bootloader includes coding file operating functions, designing MMI and implementing the start program used to initialize the portable embedded system and load the user code. The bootloader is tested and the result shows that the bootloader is stable and has high efficiency
5607
Abstract: Aimed at the problem of the embedded multi-channel video acquisition and display system, a new one based on FPGA is put forward. The configuration of the system is given. The principle and key issue is analyzed. Using of the state shift mechanism, t the controlling time sequence signals of TFT-LCD are produced; The synchronization among multi-channel video acquisition is realized by using time-division multiplexing technology; The problem of conflict between reading and writing frame cache is solved through the two SRAM switch; The frames composition technology is applied to accomplish the change from interlaced scanning to progressive scanning. The result of project application shows the virtues of system, such as good effect of acquisition and display, low cost and low power consumption.
5611
Abstract: This paper presents security rules summarized from the analysis of an distributed multidomain application. The paper proposes extensions to the core UCON model to address typical problems and requirements in the distributed multidomain environment such as: dynamic attributes, delegation authorization mechanism. The paper gives the definition of the important part of the extended UCON model such as: the basic sets, the system assertions and the actions.
5616
Abstract: This paper presents the design and implementation of voice interaction system based on ARM in service robots intelligent space. ARM Cortex-M3 core based STM32F103 is used for main controller. And real-time embedded operating system μC/OS-II is used to schedule different tasks and manage peripheral devices. LD3320 and XFS4041CN are used for speech recognition and speech synthesis, respectively. Establish a dialogue set by defining the set of two-dimensional array, and then intelligent space updates the dialogue set dynamically via ZigBee wireless network for multiple scenes. If the recognition result is got by speech recognition module, dialogue management module will send corresponding texts to speech synthesis module, enabling text-to-speech output. At the same time, intelligent space decision support system will send corresponding commands to equipments by ZigBee. From lots of experiments and practical applications, we can conclude that voice interaction systems designed in the paper can gracefully satisfy the current request of voice interaction in service robots intelligent space, having great application value.
5620
Abstract: Complex geological conditions and limited launch frequencies are the problems which the geological electromagnetic detection faced in our country. In this paper, we designed two FPGA-based detection of electromagnetic emission source inverter control circuits, one is using a phase-shift and complementary drive signal to expand the load range of electromagnetic emission system; the other one is using waveform synthesis technology to achieve that multiple frequencies could launch at one-time, and this method improves the detection accuracy. Both the two control circuits have a positive role in promoting the performance of electromagnetic detection equipment the development of Geological Survey in China.
5628